Recent content by ger84

Thank you!

Sounds like I will make sure the wires on the engine is what I will check first. Haha. I check today. Thanks for the info…

ok I will look this weekend... i assume this would b a obvious to see once i open it up. Thanks

interesting... I guess i need to open it up a little.... are you talking the control box in the truck or on the winch itself? thank

thanks for the info! i plan to make a dump bed for this truck as well in the near future.... not really thinking electric was the way to go!

I left out 125-150' of line so about half the spool was out. I mean i would have expected the winch would be awesome. I had a m35a2 and that winch had a sheer pin but it was strong and would break a sheer pin if it was too much. I will see what I can do with putting a gauge on the winch...

The winch works with a low load. Like I can drag my ram 1500 backwards with winch connected however when connected to a tree the winch kept humming and you could see the line shaking but no movement in the line or pulling of the truck forward. Is there a way to test a worn pump? Does this...

My m925a2 the winch seems weak... anything i should look at? It works and pulls in and goes out but then you would think that the winch would drag the truck on the ground with tires locked... Instead the winch just doesn't move. I was pulling a tree down with the winch but I had to back up...

is there any way to plug a computer up to this and check/manual override to engage the jake brake (test it)? I saw when I popped- the fuse lid that there is a "dig plug" or any recommendations for a computer that will not break the bank and work with Oshkosh?... Thanks

I did check the breaker and it seemed good when tested. I also purchased a new breaker just incase and no difference. I mean the parking brake works but I will look this weekend and see if there is power to the switch. thanks for the input about the parking brake switch.

Thanks for the information.... on the truck it says "contains Refrigerant" when it was sold... i havn't looked too much into it because someone decided to hit me at 60mph... so now fixing parts on the truck and getting close to done... appreciate the insight and yes Jacobs brake. thx

Hi all- So I have a m1070. My exhaust brake is not kicking on. Anyone know where I should start with figuring out what my issue is? I flipped the switch which goes from low and high but there is no switch to turn off? I got the truck with 82 miles on it from auction and looks and starts...

hello- does anyone have a CTIS cover "hub cap". I need only 1 and not dented etc. my zip is 08826. New Jersey Thank You

Hi-how’s everything holding up with the new trans installed…. Any hickups or issues? Shift and drives fine/doesn’t get squirley with the rear steer? I think mine tops out at 44mph…. Maybe 46 going down a hill. Haha Thx. Update please. :cool:

Thanks- Yea i saw that too but doesn't make sense to replace the whole bushing/ bushing is fine it just the rubber gasket boot that is dry rotted... like I know my 2.5 ton truck had zipper boots and I replaced without replacing the bushing... I donno- hoping someone has had this happen to...