Recent content by kendelrio

So the fix for that is a "new" hinge?

Ummm thanks? 😆😀😁😝

Here's a post i made on Facebook a while back regarding these wheels. For the record, I've broken down and changed the tires on my M715 approximately 20-25 times and even with precaution, have never had one unseat on me using the method I was taught (which I outline below): "All- lots of...

It's possible, this *is* an almost 60 year old vehicle, but the passenger side is nice and level and the gap is beautiful.

Ok gents- I've tried and tried, but I cannot seem to get the sag out of my driver's door. I've adjusted the hinges (I have found they move them in and out) The doors themselves And in the process got the gap too tight (Note the chipped paint) I cannot seem to get the gap correct and...

GERTY IS FINALLY MOBILE AGAIN, DONT MAKE ME NOMINATE HER! We need a full field of ten, and I know we can do it!

Was not aware of that. I'll check it! Thank you!

I checked the eccentric and pump, all was good. I got in ot and it ran perfectly.

The filter was dry. I pulled the pump and stroked it by hand and it was moving fuel. I am going to pull the valve cover today and make sure the eccentric is driving it and move forward from there, as the last thing I touched in that circuit was the eccentric. It may ha e loosened up.

Every. Step. Of. The. Way. Fuel pump is acting up now. Trouble shooting today.

Well, I had the "high speed" test yesterday. I'm proud to say she ran flawlessly! Speedo vs GPS speed, and the transmission/transfer case was in the sweet spot...

Today I changed out the oil pan gasket (the filler blocks add some time, but do a great job holding the gasket in place!), replaced the oil pressure sensor and tuned the carb. Then my A-driver and chief mechanic and I took her for a low speed short test drive. Tomorrow will be longer and...

Let's see if this works... https://youtube.com/shorts/oUMe___S8_8?feature=shared

Well, the moment of truth. I packed the new oil pump with Vaseline per instructions from several members Spent a hot minute lining up the offset for the distributor and stabbed her home. Next... time to fire up and hope for oil pressure... We have pressure! Then I went to address the...

Pun intended?