Recent content by Mack90

Make sure you get new lock washers!

that is what I ordered with no issues

I just went through this on an M817. I did replace my flywheel as it was not in good shape. There are two variety pressure plates out there. One is adjustable and one is fixed in settings. The adjustable I initially had could not be adjusted to spec per the shop manual. I would get the...

750ish will probably be closer

Following

I did not know they were labeled. It was marked ground, so easy fix. Thank you

Can anyone tell me what this wire goes to. It comes out of the same spot on the harness as the wire to starter solenoid.

The joys of auto maintenance. I hope there were no injuries.

Mine is the nhc250. I ordered the belts and hoses from Eastern Surplus. I regret not taking fan off before the belt changes. I am going to pull radiator out and take it to a local place for repair. Any idea how much the radiator weighs?

I replaced all new belts and hoses in my m817. I damaged the radiator in the process :(

Did yall find a solution to this? My cable is threaded straight to the pump. The drive turns, but my tachometer cable is not spinning with it.

I am about to take on this exact project. My copper fuel lines have seperated at tank connection. I bought a flaring tool to sort it out. Do you have any tips/advice on your project? My fuel is draining back to tank causing difficult starts after sitting for a few days. Where did you get...

I am interested in this also

The filter in the injection pump may be worth checking of you find nothing else.

I am near Albany, I would offer to help if I was in town.