-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
msgjd's latest activity
-
this thread has the pin out, you can check continuity from pin F which is power in to which ever circuit you are having trouble with... -
msgjd reacted to zebedee's post in the thread Wanted: Wrecker issued hammers/snatch blocks/crosscut saw with
Like.
I have single snatch blocks (1hr West of Albany NY). Prob going to Sussex NJ and Weare NH this spring..... -
msgjd reacted to CARNAC's post in the thread Wanted: Wrecker issued hammers/snatch blocks/crosscut saw with Like.
I have the saw in WV near Martinsburg. The 30t jack is in Texas but not with me in Corpus. Didn’t think of selling them until no. No...
-
msgjd reacted to BKubu's post in the thread Wanted: Wrecker issued hammers/snatch blocks/crosscut saw with Like.
Check with John Murray at TNJ Murray. It has been a few years, but I sold him a complete NOS wrecker BII kit. It had everything except...
-
Yes, I had to buy 2 feet, IIRC it was from the Parker dealer in Las Vegas (NV). At the time it was around $35/ft.
-
msgjd replied to the thread XM816 Wrecker - Only Took Ten Years.If it didn't leave black marks after you drove it back and forth a ways, then you are good to go.. It apparently released the tension...
-
Exactly as you said. Rolled backward in neutral until the rear tires touched the ground, then into reverse and backed it all the way to...
-
msgjd replied to the thread XM816 Wrecker - Only Took Ten Years.how exactly was it backed off? .. Rolling it down the ramps backwards in neutral (or a fwd gear) will bind it up if the air is up...
-
What should I do to test/free the sprag? Those marks were only there after backing the truck off of the lowbed, I dont think I saw any...
-
Above is all good things to check. I have put a battery cutoff switch on all my trucks.
-
msgjd replied to the thread Blackout light switch.The field-expedient way to test those switches is to have a known good one on hand.. Plug in the good one and see what changes ;)
-
I figured it’s trash but I was holding out hope of it being repairable. My unlock switch doesn’t move and the top switch b.o. drive to...
-
In the early 50's tactical lighting switches made by Bendix had TWO receptacles, one for the truck's lighting, the other for the trailer...
-
That switch has been the same since it's introduction in 1950, still being made now by various mfgrs. With a multimeter you can verify...
-
Is there a way to bench test or test one of these switches to verify it’s working? If not is there a way to rebuild the switch? It’s a...