Recent content by oldtruck51

Wanted to thank you for the info. After trouble shooting further I found the new AVR I bought had no output voltage, replaced fuse and still no output power. Not sure if it was bad when I got it or was just too complicated for this unit. I purchased an SE350 AVR off of amazon and installed it...

Here's the one from the manual. Without flashing the field I get 4.5 to 6vac at terminal 3 and 4 on the voltage regulator. When I flash F- and F+ I get 207vac at those same terminals. I've replaced the voltage regulator but get the same results.

Measured between F1 and F2 varies between 0 and 2vdc When I remove F1 and F2 from voltage regulator and put 12vdc to them, I get 207vac between the other wires (Phase to Phase) on the voltage regulator, 102 vac to ground (phase to ground).

Picked up floodlight genset but it has no output power. I have flashed field and restarted, no change. When I leave field flashed with 12v and start unit I get 108-110v to outlet plugs. Reattach field wires to Voltage regulator and start, still no output power. Replaced voltage regulator, same...

I know this has been a while but did you find a solution to no output power problem? I'm having same problem. I Flashed field and had bridge rectifiers replaced to no avail. Appears to be loss of magnetism in rotor? Any help would be appreciated.