Search results

Marvel Mystery OIL here, Use it 1 QT TO THE TANK . It is in reality not far off ATF. WALLY WORLD carries it buy the QT and Gallon , yup its red, but doesn't show up under black light .

Alternate method , use some 32 thousands stainless safety wire and run a twisted safety from the clamp forward to an anchor point, will fix it permanent Look in T.O. 1-1a-1 ( AF ) available on line and still in use, shows your good safety methods

For Airborne Infantry grunt 75 . Dam big mouth full to say that.Iam just a crusty old prop pushin Jet suck blow and go Mech . easy for me to say.. Check your parking brake handle switch, its a spring leafed micro switch in the handle assy, Two wires run down the cable tunnel and out the cab ...

Congrats , lot of hard work finally coming together

A little down the thread , but, I have broken tons of springs on my trucks over the years. My drive way is three miles of XXX 4x4 or 10x10 low range to get to my house. Just an observation, but, my spring failures are likely a case of side to side flex UNLOADED. Heavy load puts your spring pack...

don't get your deuce STUCK, unless you own a 5 ton heh heh heh lol, Been there done that , (had to buy a backhoe)

Hope you got the PayPal and shipping address

Sorry otto correct 7018 rod , 7808 is jet engine oil. I am not big fan of brazing ,it is an introduction of a third material , many times brass, although many things can be used to seep into the microscopic surface of the cracked area and is more a filler and bonding agent than a MELDING...

I must say Simp has more practical experience with the 900 series and mileage than anyone I know. I glean what I can from him and Swamp on a regular basis. I do have the lock out kit installed on my 931, but did use reverse low prior to install. Replacement is easy and straight forward, JUST...

The reverse lock out kit wont help at all if your case is already cracked. I have welded many cases, transmission, reduction gear, transfer, Of those I have only one that didn't eventualy crack again. I cant say that I have ever seen just a case for sale, On cast nodular steel ,I clean , pre...

Install the low range reverse lock out mod and solve that problem

Tons of research out there. Accepted standard is a 10% increase in applied torque when a stud/ nut is lubricated during assembly USAF T.O 1 -1-1A Works on jet engines and rockets sure it works on chevies

The MIL providers , any thing that even mentions AVIATION are out of this world, Worked Jets for twenty years , F100-110 fuel control used to be 3.2 million You can get one for under a million today Only 1/3 the original price ! ( need to buy another) I stay away from those sites, Sometimes...

Hummm, interesting, would explain the SCRAM jet leap about 5 years ago, so what metallurgy is "after" Hasteloy X

Glad to see our putting some ,miles on it, Ive had mine out for a 2o mile run , but so busy havnt been able to find time for much more, enjoy the good weather in the "convertible sports car! " everybody WANTS A GOAT.

Hey Coffey, Do you have any numbers on that match for Rustoleum Deep forest green, I use it all the time,but cant get any one to come up with a match, even contacted rustoleum via email, they refused to divulge the mix. proprietory, , would be nice to find it in a nice automotive paint

Thanks for the "LEAD THE FLEET " (LTF) evaluations Simp, I don't think I will ever reach 60 k, I am just over 4k, biggest thing plaguing mine is NOT ENOUGH DRIVING, sitting alot

Thanks for the reply, No though, I was discussing both Three and four (five even ) piece wheels in the post, The four (or 5)piece rims found on 1920s thru easy fifties on 1 ton and up trucks that are actually two half's ,cut across the entire rim, with a retention device and they fit on the...

I guess I missed the notice, Split rims Illegal, Humm not here, not only do I run them, but I see quite a few. If they came as OEM on a truck one can run them till the vehicle is scrapped, I do agree they can be dangerous, BUT having said that they served for 70 plus years , If one uses proper...

Looks good, best starting goat I ever drove!