Search results

Up for some opinions, Red or green curtains?

Adding some pic's!

Walnut it is,on the walls, for the sills,for the sink counter top. In the Throne Room!

Thank you for your appreciation Sir! During the decorative trim phases of this build,all other phases for that fact i was determined to pay very close attention to form,function, fitment and finish,over 800 LF Of applied trim was installed! From the beginning, countless hours of just sitting...

Vote for the "Taj" rig only if it's worthy of your vote!

That is true papabear!:D

The bolt in crossmembers are nice,they have an access hole so you can get a wrench on the crank bolt for rotation purposes.

Here ya go!

Here's the removable one.

Only the bolt in style crossmembers are ment to be removable.

Yes!

That fuel screw looks out way too far!

You can buy a new voltage regulator from Ericks military For around $75.00.

Replace both head gaskets instead of just one while your in there.

Do you run any wmo as fuel? Do you notice a slight ticking sound in the area of the leak?

The arm should not stay in any position you put it.

Ok,looked at it again,this pump has no HH on it, when I hold the govener rod where it should be hooked into the fuel shutoff shaft,then there is spring tension between 6 and 7 ,that spring tension is applied by the govener springs in the rear of the govener housing (round plate on back of ip)...

I have an ip sitting on the bench that i just looked at, on mine the throttle linkage arm has no spring load between 6 and seven, but does between 6 and 4:30.

Great running truck Scott! Loved the power steering!

I nominate steve6x6x6's m35a3 bobber!