Search results

I apologize . It wasn’t the oil pressure light that is on . It’s the engine high temp light that is on. And it’s on from the beginning even when it’s cold. Where is the sensor for that ?

Do you know where I could get a fault monitor if that was it ?

Hello I have two mep 831a generators both run great . One has a fault that just started showing up. It’s the low oil pressure one. The only thing the tm says is to check the valves…… do these have an oil pressure sensor? Should I try anything else other than the valves ? Doesn’t seem like the...

I appreciate the info! Very helpful !! I’d like to find the arm that connects the actuator to the governor . Any suggestions ?

Does anyone have NSN 2910-01-476-9751 it’s the telescoping linkage for the actuator on the governor for the 832a ?

Thank you ! I checked the primary and it was completely coated in sludge . And it had about 3” of sludge in the canister. I’d say they haven’t been changed in quite a while !

Just bought a 1970 deuce with 32,000 miles . It ran fine for a week or so with me driving it every other day. But yesterday I let it idle after driving it and it was warmed up and it sounded like I was a cylinder down , but when I give it throttle it goes away. Driving down the road it acts like...

Thanks for the reply. Yes I did download the tm and read through it. As long as I set it at operating rpm’s it says should be fine !

I recently just bought 2 MEP 831a generators. I noticed both of them are missing the speed controller down by the governor. Is there anyone out there that sells these? I have to manually move the lever on the governor up and down to start and stop it. Will this hurt the generator running it...