-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
Bed Side Panel Storage M1078 A1
Sometimes the panels are a little bent and the slots are a little bent. It takes some playing around to get them all in. -
-
What should the brake pedal feel like?
Lmtv braking is not like the older m939 air brakes. They are pretty responsive and stop well. -
What should the brake pedal feel like?
It should be pretty firm with air in the system. No air sometimes they do feel a bit different. Brand new pedals do feel very firm though -
1078 A0 engine starts, runs for anywhere between 8-30 seconds... [newbie ? buried in a long post]
I had a truck that did that it was sucking in air from a crack in the hose from the fuel tank to the primer separator. You can make a temporary one with quick fittings and fuel line. -
M1079 Won’t Start.
wtec3 tcm probably toast from GP trying to jump start the truck with bad batteries or no batterie. Happens all the time. I have the replacements on hand. -
M1079 Won’t Start.
What year truck. Gotta see if the tcm is getting power. The cab lift is air powered hydraulic -
M1079 Won’t Start.
What year truck? If gp tried to jump start it they could have damaged the trans tcm. No trans display power equals no start from push button. -
Fully loaded LMTV bed, thoughts?
2.5t offroad rating 5t on road the axles are 7t each rated. I had 2 huge gens in a 1078 the rear springs squat and there are frame mounted bumper arms that sit on the axle it drove around just fine -
Water in Transmission question . 1078 1997
I had a pan out one day and I looked up into the trans it appeared I could see the clutches. -
Water in Transmission question . 1078 1997
You can drop the pan/pack and look right up into the trans assembly. Thats alot of water for one leaky dipstick seal. Ive seen the fill tube hose crack before. -
FMTV wiper bottom position.
The tm has a reset procedure its the same as installing a new linkage. -
New M-1083 owner. So, here we go!!
Programming works best when its done on the truck the controller is being used on. Has to be an a1 truck. First gen trucks usually only inflate to 60 or so psi even with the controller set higher. Its hit or miss. -
LMTV radiator fan stuck
Generally a 98 is a first gen truck. Fan clutch gets stuck from sitting. Air connection over shroud disconnect and use a compressor to give clutch a blast of 140 psi air see if it frees up -
Drash Isuzu 4LE1 engine issue
That was years ago I dont know if I still have it- Suprman
- Post #16
- Forum: Generators
-
Cab and spare hydraulics problems M1078 LMTV
Sounds like a clogged restrictor -
1200lb safe Groton CT to storage nearby
I dont get up that way. Work my store counter every day. Cant it be picked up freight?- Suprman
- Post #3
- Forum: Transportation Needs
-
Looking for a new or known good Niehoff LBCD or way to remove
I have new and used ones -
-
Parking Brake Switch
Bad check valve. One of the 3 under the drivers step area. Or bad sender/broken wire.