Search results

Maybe lock a rifle to it if you hang your rifle from the windshield thumb screw ?

I have welded a few links of chain to them and used a binder to hold pressure on them and hit them with hammer .

You might measure from the axle to the frame on both sides and compare that to what other members trucks are setting at . You may just need to add a leaf or two to each side to get the height you want . I added a few spring leafs to my M211 that I made into a tractor just so it set level .

Slip yoke on drive shaft to radiator shell 2 1/8 inches grease fitting is not under the shield .

I will check when I get home in the afternoon .

Is this even close to what you need ?

Pictures of dash M52A2 with extras added . I repowered this truck with a non military Mack motor the A1 military trucks had Mack motors so I knew it would fit the block basically is the same size every thing that bolt to the sides bottom and front of the motor are different . The frame had to...

Input shaft is 1 3/4 the transmission sits very close to the frame on the right side a wider transmission may not fit . bell housing is SAE# 2

I have never taken the drums off of a LMTV but it looks like you have to pull the drum with the hub and then take the drum off the back side ? Good pictures and watch your fingers this stuff is heavy and likes to pinch .

Picture of one in the yard

Lever to shift the transfer case its in gear or out of gear. It just disconnects power to drive the wheels so you can use the winch . Lever to winch has neutral and cable on and cable off .

With a new radiator you can get the hose port the right size and where they are needed. Radiators from the 1950 do tend to be larger and lower pressure then newer ones . I would think a bus radiator would be large enough but I have not seen it . I had to have a lower hose port changed from...

I have one I took out of my 1953 . wide 23 5/8 tall28 5/8 deep 4 1/2

I would start be adjusting all the brakes .

I have found some original military paint is really tough and sand blasting is not needed it makes a ideal under coat . a good pressure washer works to get rid of loose paint and paint not on right .

I took two pictures with out a flash and two with a flash . Military equipment is so hard to see in the dark $20 worth of tape may have helped stop this from happing .

Coarse thread 1/4 x 1/2 and they have a copper washer.

M52A2 washed inside and out

Copper washer work good on pto studs to seal the threads .

I ordered two lights just like that off of Ebay for less then $20 12volt or 24volt for my smaller trailer that I pull behind the military trucks and my pickup . The light looks bright it may work good under the dash for a inside light.