Search results

I really appreciate your help. The past few "2hr" projects became half day three trips to autozone projects so I'm trying to be better informed and prepared this time! Rock Auto had the gaskets for $12 so I have those on the way.

Thanks for the help. So I've ordered a new injector and also the connector fitting the line hooks up to on the injector pump. Trying to get the injector line itself as well but finding it for the #7 cylinder has been challenging. Every other line seems to be available online except the #7...

Hi All. So I checked on the fitting. Tightening didn’t help so I loosened the fitting and fired it up for a few seconds to “wash” the connection and then finger tightened before tightening it down. It then actually leaked more than before. I tried undoing it and redoing it but I seem to only...

Supercharger?? :smile:

On the values listed above wouldn't it be 220 cfm and 330 cfm at 2000 and 3000 rpm respectively? Just multiplying the 0.11 value

If you had a "turned up" injector pump this would increase correct? The engineer in me would think so. Pretty certain mine was turned up given its pep compared to other ones I've seen and the ability to just give a hint of rolling coal when getting on it (I prefer not to roll coal!!). I was...

This is one of the best writeups ever! There should be an award for this!

Thanks, yes I was the derailer! Guilty as charged! Shiny objects distract me.

Thanks also for this great writeup on the shifter how-tos. The engineer in me loves diving into how things work. Its a lot of work to share and I appreciate it!

TOBASH, can you tell me more about the transmission you decided to go with? 765R4, is that an upgraded 700R4? I've been putting a ton of miles on my 998 since getting it doing hunting and farm trips and love it except on the highway. Not screaming at 60 mph would be nice. If I fix my...

Thanks for the info. I'll start with tightening it and see if it helps. I wasn't sure if there were o-rings or anything else in there or just a swage fit. The injector is running great otherwise, I believe it was "turned-up" a bit at Ft Polk as it seems to run more aggressive than others I've...

Here’s a second attempt at the video

Here's a terrible video of it leaking!! Sorry best I could pull off for the time being.

Hi All - So I have a leak at my injector pump that is leaking about a drop of diesel every 2-3 seconds. Its enough to make the valley on top of the engine fill during a long drive and then pour down during acceleration onto the transmission, exhaust, starter, generally make a mess and smell...

Thought I would bring this thread to a close with a final update. Pulled the starter, took it to a starter rebuild shop. $95 later it was done and was not the solenoid but the brushes were barely left, and a handful of wear parts were replaced and connections cleaned. I went to put it in with...

This is great help guys! The only way for it to be any better is if you were there in the shop helping me!

Thanks guys! Donquijote would you mind sharing the sellers name via a post or PM? Thanks again

Hi All Id like to tap into the huge amount of experience and knowledge here on an issue I’m working on. Starting this week a few times the starter has not engaged the first try. It just whirls or barely grinds then whirls. If I wait for it to spin down and try again it works fine. Its...

I'll be following this for sure as its on the possible future project list along with a 4sp transmission. Driving in the heat and humidity this weekend was tiring. My brother in law, who drove HMMWV's in the army, said this weekend he was going to stick his honda generator in the bed with a...

I used permatex "right stuff" that can be applied and is ready for oil immediately (I used the 1 min formulation). That stuff is expensive but works great and saves a lot of time and hassle of waiting for others to set up. Just don't get the fancy version with the plastic trigger device, I...