Search results

Some of these trucks, engine ecm power goes thru a filter box. Has a mil plug in and out. If you look at the engine computer look right its around there. See if you have 24v in and out. I believe the inlet heater is on the same circuit. If you have fixed your battery issue and you cant comm with...

When you run it does it put out 50 or 60 hz? if it’s 50 there is probably a way to adjust it higher either engine governor or on the inverter box.

Its a c7 with data bus. Gauges are controlled by the cat ecm

Grounds under power panel bolted up on the right side. On a bolt that holds on the passenger dash grab handle. Does the truck die too?

6500 just in labor. Gonna need a trans, lines and a new cooler too.

I have the switchbox tach housings with harness and generic mil surplus tachs that fit. They dont plug directly into the harness you would need to wire the tach to the harness.

I usually pull the motor first on a parts truck. If a cargo truck its easier to do trans work with the bed off. Flywheel bolts, bell housing bolts, lines, driveshafts. There is a cross beam over it so you have to slide it back a bit and use straps to lower it down, spin it a bit to clear and...

The switch you can order from rome truck parts. Most switches are the same. The legend pops out and into the new switch. Most of the brake components are over the counter. I dont know which valve you are referring to though.

Adding a couple big grounds isnt a bad idea. You can leave the shunt setup. It isnt hurting anything. You can add the big frame ground. If you want to eliminate the shunt, remove it and just ground the cables there.

Ok thanks. That was last year. Wes got it for me. Will

I have a good tested transmission here. Still in a truck though. Would be a few weeks before i could get it out. First gen trucks have 3 different variations of trans. Whats your truck year, serial and trans serial number?

I think most of the green ones have the same part number. I have not found a way to differentiate between first and second gen other than plugging in and seeing if they communicate

2k plus freight for a kit

It may be a flooded road.

No I never figured them out. Sold them like they were.

No. input speed sensor on bellhousing by scav pump.

Maybe a crack in the front cover of the engine by the compressor. And it sprayed out towards the compressor

First gen controllers do not have the capability of communication. There is a second gen green one and the black ones are usually 3rd gen. I use an a1 truck to program them I can plug into the trucks diagnostic port to do it. Ones with 5 solid lights are usually fried from jump starting like I...

I can program ctis. You can send it to me I can see what it does. Usually 5 lights is over voltage bricked from dead batts jump starting. That kills wtec3 tcms also. Which I can program too.

I have one here