-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
A0 winch install on an A1
There should be a plug that the accessory harness plugs into. I think it’s on the power panel side. Tractors with the switch box on dash usually have the harness. A1 harness may be a bit different though. There should be a connection that ups rpms when the pto engages. -
1994 M1089 wrecker hydraulic issue
On the 1084 they are on the manifold at each function. And there is a bank lockout for the upper controls. -
1994 M1089 wrecker hydraulic issue
On the 1084 there are function lockout solenoids. For the overload system. And outrigger up lockouts. Try unplugging them. -
M1078 Alternator Problem
250 plus 12 bucks insured priority mail shipping -
-
M1078 Alternator Problem
Did you post it on FB? Someone else did. 1995 alternator. I posted a pic of the regulator I have -
M1078 Alternator Problem
No. Long gone. I have a high output setup coming in. On a truck. As soon as the euc clears. Who know when that will be. -
Question about windshield gaskets
I have the steyr part number. Just as expensive though. I have been hunting for a generic. Has to be something out there. I can get the windshields from the manufacturer cheap. -
Power Distribution Panel repair
Fargo Dill blox bb-10l for 10 contact spaces. I think it comes in different section sizes. They are still in business you can call them. I think it comes out in sections. Most other contacts are held in with tabs. I never had to pull one of the buss bars. -
Engine losing prime
I see bad fuel filter housings and cracked leaky feed lines from the tank. I would replace the main filter primer housing and the soft lines. -
M1078 No Start...Not even trying.
They don’t usually go bad. Just missing. The truck will operate without them. -
M1078 No Start...Not even trying.
They are diode arrays. Maybe for voltage spikes. I have new ones. -
-
Leak diagnosis
Silly me. I misread. Thought you said front. ronmar is right. That is classic hyd fluid dumping. Especially if the cab isn’t folded in the pics. They tried to pump it and that was the result. Probably a bad seal on the cab latch. -
What are you using to seal up the turret cover?
The windshields dont seem to leak. Its like an old vw type. Just pushes in and you work it with a piece of string to get it all the way in. No glue used. -
Leak diagnosis
Hard to tell. Is that a gp pic? Does it say its oil? Are there engine pics? There are oil lines on the front of the motor. Front cover. Front seal. The list goes on. Need more info. -
What are you using to seal up the turret cover?
I use loads of silicone. Around the hole before I put the cover on. Around the bolts before and after I tighten them down. Around the lip. I remember that aerospace sealant. You had to mix the tube by hand and it took a long time. We used it on aav and lav antenna installations. -
Transmission indicator flashes when shifting from forward to reverse
I would start by adding a big ground wire from the battery negative to the large frame rail. Make sure you sand the spot and repaint after. -
LMTV screeching from ctis
Like a siren sound? That can be a bad hub seal. If it does its test or fill then blows off a screech at the end that can be normal. See what your tire pressure is. Higher the pressure the louder the end blowoff is. -
Stuck winch roller
Sometimes I get stuff to free up with a handheld plumbers propane torch. It gets hot enough to loosen stuff but not too hot.