Search results

Everything you wrote about alternative fuels is correct. So is the reply about filtering at least some way. Reality is that by the time you get a good pump. (Note that the air operated harbor freight 55 gallon drum one might work for about 30 gallons in my experience.). Source barrels, metal...

Do you have the solid state blinker wiring or the old mechanical Spartan unit wiring for blinkers in your new harness? As long as you have your old 3 pin plug for the box and the harness from your blinker arm, it can be made to work. I did that on my M715 which is exactly the same as the M35A2...

I’m not trying to push the Dakota Digital dash. But, it is what I have and know so that is what I will write about. Yes, the CUCV gauge cluster is 12 volt. Dakota Digital has their own oil psi and coolant temp sensors and wires. Voltage is taken from the supplied power. The tach which they...

Sorry, “Check your grounds” is kind of implied in every military truck and especially CUCV conversation. Pay real good attention to the ground cluster above the parking brake mount.

That generator to alternator kit works great. I have used it on several trucks. You also will find since your front harness is for a generator truck that it probably doesn’t have the front axle engaged light plug either. At least that has been my experience. Everything else will be close or just...

It reads like your voltage regulators are going If your belts are tight and everything else is good. Buy a pair of alternator rebuild kits is my suggestion.

I have a very good review of the Dakota Digital gauge cluster in my 12 volt Cowdog Suburban. I have Autometer gauges in my 12/24 volt 6.2 powered M715. I have a 12 volt gauge and a CUCV 24 volt gauge in the M715. So you can run all 12 volt gauges with the 12/24 system. Some custom wiring will...

You are now it seems down to what the Technical Manuals calls “Trace wiring.” I know you wrote that the wiring between the firewall and the rear sockets looked ok. But, somewhere some wires are touching.

Above the oil cooler lines is a little square headed set screw. It is blocking a pressurized oil gallery. That is probably the best place to put another gauge sender. I use it for an oil temperature sender on one of my trucks. You will look at the set screw and think a 1/4” socket extension...

Unplug the ground from the front battery before you pull the pictured plugs apart. You will find it is actually 3 different plugs going into the back of the fuse panel. Engine, front lights and rear lights. The 3 plugs kind of snap apart and back together. There will be a black goo inside the...

Here is a video I did about the ground tab on the fron blinker socket and replacement:

Basically, there are only 4 wires going to the back of the truck for service lights. There are the black out lights and the fuel sender wire as well. Have you considered the former military vehicle registration or antique registration? No inspection required. If you wait until January...

I agree. It isn’t so much the miles as the years on the soft parts.

That chili was GOOD! Don’t make fun of him.

Here are a few more convoy videos:

I’m still going through videos to see if I want to post them of the convoy. But here is everyone leaving the ranch and the flame thrower:

I’m loaded up and ready to go. I wanted to do all of this not in the mud the forecasted rain is supposed to create tonight and tomorrow.

I have a Nostalgia unit in mine but think a Vintage has got to be better. Here is a video I did about it:

The trouble with just bending a regular neoprene hose is the radius of the curves are to tight and it will kink. Braided stainless steel hose can do the curves without kinking. However, with hose clamp nipples on each end AN fittings that work aren’t cheap. Something like this can be cut down...

Don’t forget we are camping in a different location everyone!