Search results

Other helpful things to look at: pay close attention to the IN and OUT on the filter castings, Ive had these backwards before. change the filters and open the bleed screw on the first filter (center unit) and set the main switch to prime and run. when fuel leaks from the bleeder do the same...

Strainer undo the nut at the bottom of the bowl Filters take the large bolt off on the top center of the housing (think its 5\8) it has a smallwr bolt sticking out of it (1\4) that's also your bleed screw).

No, but I do controls for a living and a place would be easy to install. I did a hybrid to a 004, it's controls are intact but I added a servo and other external sensors. Sent from my SM-S908U using Tapatalk

Make sure your voltage select is 120\240. Then black to l1 white to l3 green to ground.

Need to know what the compressor voltage is. Do you have a multimeter?

wix 51004 if you need an oil filter

sorry had to get back to the office, Amazon, Wix 33511. buy 3 of them. use 1 gasket in the strainer, use the other 2 to replace the filters and gaskets. the unused filter can be used later with the replaced but slightly used gasket

I know for a fact the one from the filter kit will fit I have done it on that exact model

That's the strainer if you order a set of wix filters you can rob one of the gaskets out of the filter kit and use that

Fuel strainer or fuel filter? When you buy the new wix fuel filters they come with a gasket that can be used to replace the top end cast or gasket however they don't just sell the gasket so if you need one for the strainer what I've done in the past is buy a fuel filter and I just reuse the...

Modern problems of shipping. If you dont have it the 24p manual has all the part numbers you could need.

glad it worked. do yourself a favor and buy a can of deoxit. apply a small amount to the resistor windings and sweep it again, this will clean and help protect it from oxidizing again.

Last one I had was 9 days in Florida summer. It was unpleasant

Central FL and inland. Had a branch hit utility. Got about 45 min of runtime. Very glad to have the meps available Sent from my SM-S908U using Tapatalk

Here's the nsn

For the 2nd panel you could install an isolation transformer, that would prevent the ground loop issue

For reference: I used the -12 manual to confirm i was looking at the right switch, then the -24p manual to identify the nsn of the part.

Try this...

Ebay is your friend. I can also look and see if i have a spare in my shop. If you apply 24v to the pump (preferably through the circuit breaker) and you hear it run the caps are still good

The problem is there is no protection (circuit breaker) So you can jump the pumps to power and they click? if thats the case then there is a wiring fault we need to dig into.