Search results

Finally have a door that functions. What a pain in the rear. I decided against buying the little plastic clips and just bought the whole assembly. I was going to be half way there by the time shipping was charged. I never want to mess with those rods and getting my arm inside that door again...

https://shop.areadieselservice.com/ They can take care of you

looked at that page before. still dont know what it is. Its metal so its not the seal part 6 or 7

Veritread is just a brokers broker. what are you shipping i can put you in touch with my broker or a transporter direct depending on where its at and where its going

This picture is the part that was laying in the door. I do not know where it goes

So been a while 2 steps back ok n the door went to put everything back and the door handle broke ordered a new one its been to cold to work on so now that its nice went to install the control rods and the plastic unobtainable nub is broken so I will be ordering from MME today . While I wait I...

Cannon came through for me and sent a manual

I wish the guy bidding from Ohio would check Facebook. I could sell him a 1040

i contacted the manufacturer today and they said they had not produced that load bank in about 30 years. He was going to try to find a manual for me. said the anderson connectors are 175amp and the biggest problem was the fans which are $1500 if they are bad

4 pins and 2 ground wire and the whole platform lifts off. tank is only on the top front there. In this case in front of a 1040

That is part of a Drone support trailer. I have two trailers with that plat form. 30 Gallon fuel tank, also a spot to put a mep 531a and lock into position. plus the mep 803a

I believe the inputs are just anderson connectors so i will have to figure out what size those are. just read the manual for another cannon load bank, but for one that will do 480 looks like this is pretty straight forward 1 or 3 phase 120, 240, 208. Never used a load bank. I will try to write...

Meter knob is broken, but have not messed with it other than that. Everything inside looks like its in good condition. Hopefully going to be a good unit for me.

Bought this in a pallet from Gov Planet. can't find information about it on Cannons web site. No manuals any help or information would be appreciated

Northwest Ohio its 21 degrees and sunny. pretty happy with that

Make sure all the air is bled out of the system and that you take the injector nozzle apart and make sure its not clogged or not seated all of the way

I have 3 1040's for sale if you decide to go that way.

unless it runs on the auction ad. i would more than likely consider it a parts machine or at least one that is going to need engine repair.

10-32X1/2 Slotted Hex Washer Head Machine Screws 18-8 Stainless Steel (50 Pcs) #10-32 Stainless Steel Locknuts with External-Tooth Lock Washer,50-Pieces,Kep Nut 10-32x3/4 Stainless Steel Slotted Hex Washer Head Machine Screws 18-8 Flat Washer SAE 18-8 Stainless Steel your going to need these...