Search results

Hey guys I have seen this question asked but have not seen it answered. The TM's call for 2.6 pt of fluid for the winch, Now is that for the DS of the truck or the PS or both? My winch does not have the self level wind. I am just servicing all my fluids. And I got fluid out of both sides of the...

looking at the winch from the front its on the driver side on the bottom. The fill plug is on the top and it was square to now round but i can build onto it and get it out and re tap the hole but I want to be able to get the drain out so I can flush out and debris that falls out. The pass side...

Yea it is a hard top. with the door open it rolls up feels like its riding up in sandpaper. I roll it up the then close the door and finish rolling it up to well to be somewhat water tight lol

I have a question I installed a winch on my A2 everything works good except for the the lever you unlock to use the winch. I have to put a pipe on it to move it and it makes a crack sound when it does move. I am hoping it's from lack of use but I am nervous of that sound if that handle breaks I...

can anyone tell me what might be wrong with both my windows DS/PS when the door's are shut they are extremely hard to wind. Open the doors they are better but not good. I removed the access panel and greased and lubed the tracks etc still the same stiff.

Its not what I have done to my 5 ton. But it became a motor home to a Robin who decided to build a nest and lay four eggs on top of my rear diff. I will be nice and wont move it until their gone

I replaced all my Differential fluids and Transfers case. And greased everything. I think I will give it a bath, Then time to start painting the inside of the bed

I tried going to a straight pipe on my A2 I cut off the flanges off the old muffler and welded them to the straight pipe had to modify the top muffler bracket. It sounded great at idle. Once you pressed the pedal oh my it rattled my brain. Took my wife for a ride and she said pay the 300 for a...

Got the oil changed today, Had the wife up standing on the tire, I was handing up the oil to her teamwork.

Finished the winch and it works!!!. Now I will change the oil after work tomorrow. Then start looking at my m105a3

Installed a 20K winch and short hood prop on my A2. Still fighting with the PTO fork though.

Thoughts and prayers are with you and your family.

I drove from PA and personally have a met smittyjr355 for and item. He is very honest and helpful. I would have no problems giving him the info if it can help you

I had to loosen the engine bolts and move the tranny over to get the pto in very tight but it can be done

I have an issue I just installed my winch the PTO sucked lol but its in now. the SQ fill plug on the DS buy the lock handle will not come loose I have tried heat etc now its more round then SQ. And the clutch handle will not move unless someone is turning the spool by hand and you have a cheater...

Yea I believe it is off an A1. Is that the only difference. I read someone say about a longer drive shaft I don't know

the dash plaque says 1990

thanks for the amounts. I feel stupid after sending the question about the atf i looked at my winch again and realized that it didn't go through the winch the only thing the atf lubricates is the PTO on my transmission sorry for the dumb question. Im putting this winch on a M923A2 with CTIS and...

I got a question i have been looking through the tms for the amount of fluid the winch reservoir takes and i cant find it. I can find the gear case 2.6pt but not the reservoir. I just got my complete winch setup Sat and just putting all my ducks in a row before I install it. I have also switched...

can anyone tell me where I can find a Hard copy of a service or repair manual for a 1990 M923A2? I have a brand new Tm for it but it does not list part numbers or repair info. I.E changing your tranny fluid it says get it to the shop for the mechanics to look at it that dose not help me. I have...