Search results

I have a control cube i can sell but its pricey. I love my 1040 but these fancy electronics are always and achilles heel. Check the ground strap first. You can take these boxes apart quite easily.

I have a battery tender 24v maintainer and a batteries plus branded 24v charger and maint. I lije the batteries plus better and it was 120 bucks.

Ok, im going to have to correct your friend here. I have 5 of these units in the lot right now and the newest, an early 90's unit would not start. I suspected the magpickup. Took it off, cleaned the tip and reinstalled it to 9.5vac. Started right up. How did i get to 9.5vac, well i took the...

I always wear gloves when dealing with gensets. Cheap lifesaver.

Howdy folks. Need a ride for my Hmmwv from albany to jacksomville. Anyone make that route?

Where did you get the kit?

Found them under a Bosch part# ADN6S526. Thanks for the help.

Howdy. I need new injector tips for a 003a im rebuilding and cant find the rebuild kits or the tips. Anyone have any to sell? Im also looking for the injection pump rebuild kit but ambac is out. Thanks

I actually just received my 813a today. Bought it to to replace a seized 803a. Spare parts is what these 400hz units are good for. You can use the genhead as a good boat anchor. Let the fun begin.

Howdy. Ive got 2 mep 007b 100kw units that need a lift from Klingerstown Pa to Jacksonville Fl. I will even throw in a free trailer if you want it.

Rubber hose with a pex brass plug then a clamp and presto.

On a side note, make sure you retorque the oil pan. These white engines love to leak oil. Also, check the oil drain valve, I end up changing them cause they leak. The best part about this series is that they can be reconfigured to single phase.

This is the first thing you need to realign. Tb1 or voltage reconnection board.

Omg! I was about to buy those 3 units when they came up for auction a month or so back. They looked great till you looked closer. If i recall, the listing said these were experimental or something . They had many empty cutouts and it was obvious they were missing a few electronic components. Its...

Manual says .69 gph.

FYyi, they are back in stock for 70 bucks at classic industries. https://www.classicindustries.com/product/25053623.html

Will check this. I pushed the easy button yesterday and jumped s1-8 to the shutoff just to get it working since i could not find the fault. At ome point only 12v was coming through.

S1 is properly wired. There is 24v when s1 is at prime & run on 3468.

Its not getting the 24v to the shutoff. S1 works fine and unit cranks.

Its actually the fuel shut off and not the governor actuator thats giving me problems. Its droping voltage on its way from the battery through the panel and to the shut off. If i connect it directly to the battery, it works fine. I recharging the batteries to full capacity to make sure its not...