Search results

I like Napa premium in the blue and white tube or the large tub . When repacking wheel bearings they take a fair amount of lube . I want to always use the same grease on a bearing that I used the last time I had it apart . When I bought my m211 in the 1980's I bought wheel bearing grease...

I had a loose wheel bearing cause the front end to shack on my m52a2 .

When I changed the boots on my m52a2 one was full of grease and one had grease in it but not running out this boot is fine and the over full one is needing replaced again . I plan to take them a part and clean the way excess grease out .

This Is the split rim that should never be used .

These are 2 inch pipe 10 feet long .

I did change the ends . It's been almost ten years .

I had bought Aeroquip ends and hose when replacing the coolant lines on my truck .

Yes it and 3 more ldt engines I bought at a yard sale need to go .

The LSD is still here . I don't have any plans for it there are not a lot of people interested in military trucks in this area .

I drove m52a2 with the Mack 673 engine around the yard today . I thought I might have problems with the clutch and power steering .The bell housing disk and throw out bearing are military and the pressure plate and fly wheel are civilian . The power steering pump is from the LDS engine and it...

Taking it a part I heated up the nut and used a hammer and punch .

I bought a 2 inch wrench used a grinder to open it to 2 1/4 . then when I could not get it any tighter I used a punch and a hammer to snug it to the next hole for the cotter pin . it is something I watch it has not loosened up .

For my 5 ton I have Progressive commercial . $ 83.00 a month

The intake ports should have metal rings between the head and manifold if not in a short time they will suck in air .

You might try researching the cable on line and see what you find . you may have a good find .

I looked in one of my manuals to get these weights . You may have to strip it down to find out ? M 211 with winch 13,580 m221 with winch 12,105 ( Tractor model)

Good pictures .The military mack bell housing is the same way I had to use silicone to seal between the block and bell housing .

A few years ago I towed ( Area 52 ) M54A2 with my M52a2 through town to his house .It was not bad I had one sharp turn leaving the county road I though the m54a2 would push my tractor to the side but it did not I skidded the m54a2 front end over it pulled right along after the turn .

Memphis Equipment has the best shipping when I order on Monday there parts are here on Thursday .

I use these on my 5 ton I haul water with I have to back down to the water and place the chocks behind the trailer tires when loaded I drive up till a level spot an walk back to get the chocks . I have used the rubber chocks they seam to mash down from a loaded truck or trailer some times they...