Search results

Fuzzy , Found software on internet recommend any version number?

Check for power to and through CB42 on you PDP fuzzy what are you calling the pdp? passengerside dash panel? I have been trying to figure my abs light for years I do have cat et , but not the wabsco software for abs , so been trying manual to figure out playing swap a part! Marty

there a place where I bought some 4.7kw that will fit the yanmar 7 hp that is in the mep the guys name is shane huffman and you need a gen to fit the j09b size. IMD LLC Tel.: 864.968.0858 Ext:1014 Fax: 864.968.0878 www.imd-us.com

yes the guts are the same from what i found!

I have finally tracked down the manufacture for the lmtv air hydraulic pump that lifts the cab lowers tire etc. it is made by spx/otc you can rebuild it by using the internal parts that come from their 4023 and pa50 models the most common part that goes bad is called a Ucup part number 253095 or...

Hey Juan just wanted to update you I am going only in 5 ton camper to air show , not bringing the lmtv. So me and family will only constitute one vehicle.

Me and pretty much whole family will be there Saturday and camping at signet

Me and shelly gonna be there Thursday eve

I haven't looked at mine but all of them are switchs the two in back,one for front bucket is a single pole double throw temporary on off on. The other is on off amazon sells some that snap right in that are similar as for the tool switch it's a pull on switch on off you can get that at napa. It...

I plan on coming got to get some stuff in order but will give 100 percent notice on 14th.

this will help also you got to find the wire 22 in under the circuit board /fuse panel and cut the one going to the rear connector and this is the brake controller output, tie your controller output to this wire, if I remember there were two one going to the front and one to the rear. all the...

its probably the regulator its turns on/off the 12 and 24 charging intermitingly thats the lil lights that blink back and forth basically cycles 12 then 24 and the 12 side is not working which is most common problem with the regulator fail, I change them on my lmtv camper almost every other year...

mouser electronics is in texas, just google them been doing business with them for over 20 years good people!

Heres the connector and sockets for the battery pack you can get from Mouser electronics 538-36648-0006 and 538-02-08-1004, I will make a drawing of what wire goes where later but if you open the lid on heater you can see it pretty easy, there is a grayish/white which is pos of battery one, and...

Been looking for a long time for this part for Scepter fuel can part, but I found the right umbrella flap valve for the gravity cap used with heaters like sha,shs and sch35 etc. on the fuel cans they can be bought on Eba* look for "holley umbrella valve qft aed forc carb check valve" you can...

I have a question, ever since I have owned my mog whenever you put a load of dirt into the front bucket the power steering belt screams , I have tryed different belts and tension etc. Does anybody elses mog do this? Thanks Marty

Anybody got a battery pack for a hunter shc 35 or 60 doesn't have to be good but intact I think I can rebuild it.

looking to see if someone is going to Butner nc then heading southish kinda towards Louisiana? Got a crate 56x72x34 proly 1k lbs

They are some smalll shelter heaters (SHA)just sitting on a pallet if I could get them shrink wrapped, or boxed so that a ltl truck can pick them up or if you want just pickum up, place in box and ship ups I would pay you for your time. No trucking company will pick up as is. Thanks Marty

Looking for someone who can shrinkwrap a lil pallet of heaters so I can get a shipping company to pickup, in Colorado Springs, Co. at GP yard. Will pay for your time. marty 3373198104