• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. M35A2-AZ

    Opening up the rockwells…

    Yes, A good 1/2" impact will do it.
  2. M35A2-AZ

    Opening up the rockwells…

    You almost have to use a impact. The ones I have done that is what I did.
  3. M35A2-AZ

    M939a0 Super Single Conversion

    You need the same Lug nuts that are on the front.
  4. M35A2-AZ

    M923 Bedliner Paint Job

    I did a M35A2 bed with it. I used a Raptor liner kit. It looked great.
  5. M35A2-AZ

    M35A3 Smoking Alterntor

    I would try to get your voltage gauge working. Also have you put a volt meter on the Alt.?
  6. M35A2-AZ

    M35A3 Smoking Alterntor

    Are you batteries good? The bearings in the Alt. maybe bad, take the belts off and see if it turns ok.
  7. M35A2-AZ

    Wrecker Swing Gearcase Rebuild Notes

    Nice job with the rebuild.
  8. M35A2-AZ

    Oil drain valve

    I also have the Fumoto on my M939 trucks also. They work great. Just a little slow on draining.
  9. M35A2-AZ

    Throttle Cable and Engine Stop Cable Issue

    I forgot about that, you are right.
  10. M35A2-AZ

    Throttle Cable and Engine Stop Cable Issue

    It should be clamped at the pump end I think.
  11. M35A2-AZ

    Throttle Cable and Engine Stop Cable Issue

    That looks to be in the right place.
  12. M35A2-AZ

    New member from Arizona

    Welcome!! Come on out to the Buckeye Air Fair this weekend. Our club is doing our annual show there. http://www.armytrucks.org/mvshow.php
  13. M35A2-AZ

    front axle seal leak

    Looks like a nice install on the speedy sleeve!!
  14. M35A2-AZ

    M813- Wire #40

    I think wire#40 is for the panel light. Should be ok, but you may have to have your panel lights on for that to work.
  15. M35A2-AZ

    Can this be moved?

    It is a vent for the fuel tanks. You can move it, but remember not to go to deep in water or you will get water in your fuel tanks. That was a upgrade in the M939 trucks.
  16. M35A2-AZ

    Simp's M816 Bringing back from the dead thread

    Now that looks like a great project!!!
  17. M35A2-AZ

    Shutting Down M817 Question

    Sounds like the fuel shutoff solenoid on top of the IP pump is not working.
  18. M35A2-AZ

    5 ton M929 Transfer case won't shift into low

    I think that is a good idea to try.
  19. M35A2-AZ

    m939a2 tires leak out on one side

    It can affect on the same axle, but I do not think it could on the same side. But I'm not sure.
Top