Search results

your truck looks to be in very good condition. My cab was toast . Did you do a multi-fuel swap.?

maybe we should start a club With t-shirts and everything. I‘m thinking 2023 is the year mine runs, drives,and stops.…….MAYBE

i told myself if I didn’t make any progress in 2022 I was going to get rid of it. (Which I really didn’t want to) so Little by little it has been moving along. Still plenty to do. I’m hoping the air pack is good but it most likely will not be.

Was able to get the rear u-bolts out. The passenger side is done. M35a2 front u-bolts are almost a direct replacement for rear m108 u-bolts

Done any more to the m108. I’m still working on mine 7 years in. Lol

Well you may be correct. The front ubolts he has pictured look correct for my rear . I will reach out to him.

He would not have these. They are twice as long and have a different shape top than the m35a2 u bolts

Ok 8 years in and still working on the truck. It is still moving along. Recently installed all new wheel cylinders and completed the bearing service all the way around. hoping the air pack is good but with my luck and history with this truck its probably not. in addition I have removed...

Yes you have to get to use the competitor look up function . The code goes in there as the competitor . That’s it.

Glad it’s fixed

I was asking about the brake booster vent line but thank you

Where is the vent line?

The u joint axle shafts have had the washer/bushing removed from them in order to get enough clearance with the old style seal retainers

cleaned the tank and new fuel pump too.

Longest thread ever I know. I am now going through the axles . Ran into an issue with the axle shafts being modified so I had to pull everything from my parts truck. Ive got it all about ready to put it back together .

in addition to the above I would pull the drums and inspect all wheel cylinders And go ahead and repack the bearings. it Probably needs new boots up front as well So go ahead and pull the hubs and knuckles replace them and pack axle shaft u joints with grease . Its the only way you will know...

Best pickup you will ever own

probably not your issue but I think the original fuse was a 2.5 amp. . I run 3s in my trucks

I was able to remove the retainers and axle shafts from my donor vehicle. Also got the new pads and wheel cylinders while I was end there. Modified a big puller with a homemade end to pull all the retainers. At some point in time someone really boogered up the housing on the driver’s side. I...

I should have everything needed in my parts truck . Wish I had inquired before I started putting it back together. I put the seal and shaft together 2 days ago. Will post what I find in the other side.