Search results

I bought a LMTVA1 that has a broke transfer housing when GP picked it up with a forklift, I been able to find replacement transmissions/transfers but they are for the older model LMTV and not the A1, I know the older are WTEC2 and this one is WTEC3 but is the transfer the same. thanks Marty

Just got home 14 hrs had great time and thanks everyone for a great trip and great people!

LOADED and leavin god help me!

Loaded and ready to go will be at CSM Davis's house tomorrow afternoon!

Thanks finally found the drawing in the tm also it must be my fail safe not out puting or there seems to be if I am reading the diagram correct that one wire from fail safe go to light switch maybe there's a bad connection there do you know if you have the light switch to all off including tail...

I'll take at the rally thanks marty

Starts Oct 20-23 at Durumtown Ga, near Union Point don't know if I spelled D-town correct!

MsMog I am going from 90 to 59 to Jeff Davis (CSM Davis) house in Hattisburg, on the 18th then leaving from there daybreak on 19th to rally, also in box cleaned up! Marty

Bulbs good, ground good I removed the wire going to each bulb and hooked to 24 v and they both light up does the fail safe unit drive the bulbs because I am not getting any voltage to the wires coming in, trying to figure where the voltage comes from for these two bulbs I dont know if it is from...

I can bring 5 SEE tires with me to the Georgia rally but I want to get rid of all of them for 500 they came off my SEE cause I put 365's on it. They are about 90 percent and one has never hit the ground! Marty

Lately my low air pressure and emergency brake lights have not been coming on when I first start truck the warning buzzer works fine and shuts off at about 60 psi and buzzer comes on when emergency brake is lifted/pulled on, looked in TM's and replaced the two low air pressure switches on air...

The base of the backhoe is ductile but the where the bucket is it is not because the whole arm is welded down the center and the pad eyes for the pivot bushings for bucket are welded on also , I have welding a thumb on mine and it works great, bought it of of ebay and haven't had any trouble...

put me down for the gas cans! If nobody grabs them

If anyone is interested I will bring; 5 ton series.a1 power steering pump. 50$ Sold swamp donkey hmmvv? Condensor - $50 hmmvv? Evaporator - $ 50 MBU Compressors - $20 MBU series 3 control panel new in box- $100 each detriot 453 series with transmission think it's for a 10k forklift looks new -...

The only problem we have here is it gets to hot in them plastic stuff almost melts on stuff usually gets almost to 150 degrees sometimes in the summer inside. we found that if you add a small solar panel and hook it directly to a small computer fan and draw air from one side to the other it...

I get with you on the intake exhaust manifold. Marty

We can leave whenever I should be at your house the day before around 1 pm. I will probably tank up before I get to your house also I carry 110 gallons of fuel on board. marty

Dude you should take your big boy you will not have to,pull a trailer then.

thanks, marty

I to put the michelins xzl on mine but I used the 365/85/20 s and it drives 500 percent better I drive 45 mph easily on the road and have basically bogged it down to axle in mud and not got stuck I have three 365/80/20s which I will put on. Once it get the fourth , with the 85's they will rub...