• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. 2

    Can I revisit wet stacking?

    Great stories. I can only imagine trying to clean/disinfect a pager that had been deep in... I'm curious what did the plant make? All the best, 2Pbfeet
  2. 2

    Feasibility of Solar Panel augmentation with existing MEP backup/additive power or just add larger genset?

    I would keep looking for your desired MEP-003; you have many of the spares, and know the '002. FWIW: We have had wildfire smoke bad enough to cause a 90% reduction in solar output. That drove us to upgrading to a MEP-803A. One thing with planning a solar+generator+battery that I would...
  3. 2

    New owner of MEP 802A

    I wish I had seen the selectable load models! That would have saved me some work. I bought a dented 10kW, and rewired it for 1650/3300/4950/6600/10,000W. Internally, the control boards seem to be laid out for possible 3 phase operation, but I did not find those models for sale. FWIW, the unit...
  4. 2

    Can I revisit wet stacking?

    FWIW: a while back, I bought a used Onan 5500 with close to 5000 hours on it. It didn't run that well and smoked a bit. I serviced the fluids, add carb cleaner to the fuel tank, changed the filters and spark plug, started it up (smoking), then gradually loaded it up to full load and ran it for a...
  5. 2

    New owner of MEP 802A

    If it is rated, great, and F-4040-A is hydrocarbon rated, so you should be good to go. (y)(y) (And thanks for correcting me; good to learn something new!) All the best, 2Pbfeet
  6. 2

    MEP 805A Libby Voltage Reg. Retrofit

    @Guyfang Eagle eye!
  7. 2

    New owner of MEP 802A

    Tygon comes in a variety of formulations, all PVC based. As far as I am aware, none of them are deemed "recommended" for diesel. If Tygon is being used, I would keep an eye on it, as I have seen it swell and soften in fuel line uses, though I have only used it in an emergency. (EDIT: I'm wrong...
  8. 2

    Need some help picking a generator for single-phase and 3-phase use

    Nice job, regardless. I'm I the same boat. It is a great incentive to just roll up your sleeves and get it done, when you know the buck stops with you, so you just dig in and have to get creative. ;) I think a fair amount about prior generations who didn't have the luxury of power tools and...
  9. 2

    Need some help picking a generator for single-phase and 3-phase use

    I haven't managed to find a CAT at a price that makes sense for me. There are too many folks around hereabouts that can keep one busy earning money, and pay accordingly. @MatthewWBailey That is impressive work with that boulder! Biodiesel is great if you can find a local, and cheap, source for...
  10. 2

    MEP-002a only outputting 125v

    Nice attention to detail!
  11. 2

    MEP-80X Blow by

    FWIW: Also on Amazon.
  12. 2

    MEP-80X Blow by

    That's an insight and half! Many thanks! All the best, 2Pbfeet
  13. 2

    Need some help picking a generator for single-phase and 3-phase use

    That Husquavarna is impressive. I really like the load LEDs that seem to make it a lot easier to stay within the loading of the drill. I am in the process of planning on adding a ground mount array, and I know that I will hit rock somewhere. Some of the rock is barely aggregated limestone, some...
  14. 2

    Need some help picking a generator for single-phase and 3-phase use

    There are lots of ways to skin a cat... We lived in a house plumbed like that for awhile, and it was basically "free" hot water, though I might check the stove temperatures before you get too far into it; most of the versions that I have seen use steel, usually stainless. If the water heater is...
  15. 2

    What trickle chargers are you guys using?

    Dual 12V 20W waterproof solar panels with built in charge controllers, one wired to each battery to keep them in balance.
  16. 2

    Need some help picking a generator for single-phase and 3-phase use

    A half HP well pump should be generally pretty easy to handle. However, the LRA on your AC may set your minimum generator size; 69A is a chunk, and might put you up into a 20kW unit, if you can't install a soft start to lower that number. Can I also suggest considering moving to a heat pump...
  17. 2

    Need some help picking a generator for single-phase and 3-phase use

    @MatthewWBailey On your earlier post with the solar array going in, that's a heck of a hole. I was looking at the hole picture, thinking that looks like a big chunk of granite, thinking "how the heck", and then I saw your second photo. That's one of the largest diamond core bits I have seen on...
  18. 2

    Too much of a good thing, MEP-803a wouldn't stop!

    The Jim Beam was a nice touch. I can only imagine how well the indiscriminate use of fire extinguishers went over with a bunch of "regelmäßig und ordentlich" German firemen.:ROFLMAO: Thanks for the morning laugh. All the best, 2Pbfeet
  19. 2

    Too much of a good thing, MEP-803a wouldn't stop!

    Those darn mice are such a problem!;) So how big and how many fire extinguishers were stocked? 10lb CO2? 20? Did they get refilled on site? Just curious. All the best, 2Pbfeet
  20. 2

    MEP-531a Aftermarket regulator/project

    @Skyhawk13205 congratulations on the fix! All the best, 2Pbfeet
Top