Search results

Can anyone tell me what this wire goes to. It comes out of the same spot on the harness as the wire to starter solenoid.

Has anyone extended their axle vents to a higher location? If so, where did you extend them to? I am thinking of doing this to keep water out of axle. Any thoughts on this?

I looked at the manual and 200 to 220ft/lb was the spec. I cannot get it torqued down without the motor starting to turn. Do any of you have a tip on how to keep motor from turning while torquing bolts?

There are different design pressure plates I have found. The one I pulled out of the truck has no adjustment that I can find. There are three screws for the clutch fingers. I am trying to set ip my new clutch per the manual. The I have dialed in the first adjustment. I am having issues...

Hello All, I am about to change the coolant and hoses in my M817. I bought Zerex original green antifreeze and am trying to find and equivalent for the Mil-A-53009 antifreeze extender additive that is in the manual. Is this an SCA additive? How much do I need? Do you flush the system? If...

I am getting ready to replace the clutch on my M817. I am seeing button type and standard disk style. What are most using when they replace their clutch?

I have a M817 that I just changed the oil and added an oil filter spin-on adapter. It came with no instructions. I put the included gaskets on and torqued it down. I am now leaking oil where the adapter mates to the old filter base. I am guessing I failed to do something simple. Is there an...

I just replaced the starter with an new reduction drive unit. The original starter was getting 24volts, but only made a clunck and didn't really turn the motor. The new starter is also getting 24volts, but doing the same thing. Do any of you have an idea on what to look for next? Thank you...

Hello All, I am learning the ins and outs of a M817 I purchased. I have been reading forum for a while and now joining.