Search results

I have been unable to find anyone talking about bleeding a new master cylinder for a deuce. Is there a bleeding procedure before installing it or is it just gravity bleed by opening the bleeder on the air pack? Next question is the new MC came with a rubber cap that is not vented, can this be...

I got two 2.5 Ton Fire Trucks the other day and just looking around, there doesn't seem to be a lot of them out there. Is there some kind of way to find out how many were made? Or any other information on them? On one the tag says M45-FTL-1 and the other M45A2. Here is a picture of one, the...

I took the SF97 to the tax commissioner in my county to get the title for a 1977 M36A. In GA anything 1985 and older doesn't require a tag, so their system was not allowing her to complete the title request. Has anyone on here been able to get a title from a SF97 that is older than 1985 in Georgia?

My transfer case will not shift into low. I have followed the other post on here that say it has an air lock and it should shift with all the air out. It still doesn't, I took the linkage loose to make sure that wasn't the problem and it moves fine when it is disconnected from the transfer...

I have a M929 5 ton dump truck with a PTO problem. I have searched on the site for anyone who has removed a PTO with no luck. I have located the procedure in the TM but my concern is the frame of the truck. There is not much room and I wanted to verify that it can be removed without dropping...

I have a DHS Systems 19-6344-003 20Kw , 96000 Cooling BTU, 46100 Heating BTU unit that I'm looking for info on. I have not been able to get it to run yet and I believe the fuel system needs priming. It has a Lister-Petter 4801991-LPWT4A079 4cylinder diesel engine. It has about 2000 hours on...

I recently purchased a MEP 016E. It was missing the voltage regulator. I bought the SX460 and wired it in place. I put in the 5 amp fuse as shown on one of the details I found. After starting it up, it was only putting out about 33 volts set to the 120V 1P setting. I tried adjusting the...

I have a M1028 with the 37" hummer tire & rim setup that I have been running with no lift, only trimmed front fenders. The tires rub when I turn too sharply but I have just been dealing with it. After seeing the 1" Zero Rate spring that a lot of people are using with their lifts, I though it...

What is in the compartments on the outside front of an M750 trailer? Or what are they used for.

I have had 2 CUCV that I drove on a regular basis that the front battery would die before the rear would. The batteries were bought new at the same time and installed together. The first time it happened to was a M1009 Blazer and I had starting issues with it and I just thought that was the...

Any chance of anyone picking up something in Pensacola(and going to GA) in the next 2 weeks. I have a dodge tug that I need picked up. I am planning on going 1/7/10 if I don't hear from anyone. I will have room if someone else needs something picked up.

I have been following the postings about installing the 5.9 cummins into the M1008. I know these motors were used in buses and was wondering if this would be a good source for obtaining one. Is there any difference that in these motors that would prevent them from being used? Next question...