Search results

I installed the brass well nut recommended in this thread in the drain hole. I used the green mountain one in the upper hole. The green mountain one works but is complicated compared to the other and there is no groove for the o ring. I would stay with the one recommended in this thread. It is...

I was only able able to locate one of the brass well nuts recommended here. I will use that in the lower drain hole. I am going to order the green mountain one for the upper hole. I will take one for the team, and let you know how it works out.

Tank depot has them in stock

thank you

Its definitely not for the exhaust, too small . Ok, so this thread is the correct well nut to use? https://www.steelsoldiers.com/threads/ultimate-well-nut-repair.171091/page-8

That makes sense.

Also, time to replace my well nuts and read quite a bit but I have not seen the recommendation to use these https://greenmountaingenerators.com/product/mep802a-mep803a-fuel-tank-well-nut-a3816/. They seem to be the best option.

Everything is good with the muffler so I guess it must of been replaced and the old one dropped.

I discovered this piece inside the cabinet. Any idea what it's from?

Time to replace my well nuts. Why has no one mentioned this setup? https://greenmountaingenerators.com/product/mep802a-mep803a-fuel-tank-well-nut-a3816/

Add a zero and you got a deal.

Glad to hear that. Thank you

I just did a 2 hr load test from 100% to 125%. It ran perfectly. I have a question regarding the rust in the picture. There are no leaks but it has me concerned. Is this rust normal where it's located?

Yes I removed the fan guards.

Hello, This is my first post. I recently won an auction on a MEP-802a with 90 hours from Gov planet. The winning bid was $2600. Upon reviewing the paperwork that it came with from the army it had me concerned. On the red label it says 'Unserviceable, does not meet repair criteria". There is...