Search results

Can anybody tell me what the Ohm readings should be on a 24 Volt water proof ignition coil for a m37. I have weak spark and I have a new set of point and condenser but want to make sure the coil is not bad

I dont have a spare 24 volt coil.

a.stalzer83@gmail.com this all you need

That would be great

For some reason i cant get registered on the G741 Forum to see the float settings.

I have not pulled plugs out but plan on tonight.

Can you tell me what the points Gap should be and what the float level of Carb should be. Right now the thing is setting in my headed shop at 60 degrees and it starts very hard cold. It acts like its flooding itself out the only way i can start it is have to hold my foot to the floor no chock...

Any ideas of why my 1954 M-37 starts hard cold. I just recently rebuild the carb and when the thing is running it run nice. Since i have rebuild the carb and adjusted the points to .020 it seems to me that it dont want to start when its cold. This thing is sitting in my headed shop at 60...

Whats the place to check vacuum at on the manifold

I did spray all gaskets around the carb with either had no leaks. I will get a vacuum gauge and report back.

I have a 53 M-37 have owned it for 15 years. Hasn't been driven for a few years. When it was parked it had a dead spot off idle. I just pulled it out of the shed to work on it. I purchased a new carb kit from Mikes carburetors. Polished up the accelerator pump and the bore. Checked the...