Search results

The low fuel light was on with the low oil. I filled the tank but the fuel gauge only comes up to 1/4. Now when I set to run I hear no fuel pump till I turn on the Battle switch. It will start and run, but as soon as I shut that down the engine shuts down. Which way is the IP handle supposed...

Guyfang, I pulled the 1 amp fuse and replaced it. Hooked the Batteries up and the the test light for oil low pressure was on. Pulled the lever and the lights came on and then went off. Replaced that fuse and the only light besides the oil was the low fuel light was off. Tried to start but no...

Hello again, I followed your directions and I know you would never believe it!! It turned out that it is the brand new fuel pump that I had replaced with the IP. That is a step in the right direction, but then comes the new issue. I turn on the Battle switch with the new pump un-plugged and the...

Hello, At first it would run fine but there was a problem with the IP causing it to shut down . Had the IP rebuilt which was the only thing I had rebuilt. It ran fine at the repair shop. I get to my shop and the CB-1 starts tripping. I followed your directions earlier. I found no burnt or...

How's it going? I bought this a year ago and it has been one thing after another. Now it is the CB-1 breaker. I know nothing and the electrician's around here when first approached scratch their heads when talking a military piece. Still hopeful. Later

I live in Cornelia, Ga. I have a MEP 004A 15KW, it has been an adventure to get this unit to run at my shop, after I bought it or after I had the IP rebuilt. As soon as I got it back it started to trip the 7.5 CB-1. I have been trying the suggestions that have been offered. Is there anyone near...

Trying to sort out MEP-004. A few months ago was fighting fuel issues. Rebuilt IP, ran fine when picked up, Back at the shop it will run for less than 1 minute and the 7.5 breaker trips. Reset and restart with same results. Any Ideas, bad breaker or time to call electrician?

you were right Re-set started right up for 15/20 seconds and Ray lets try this again. You were right 7.5 tripped. Re-set ran 15/20 seconds tripped. Which way should I go now? Did not smell anything burning . Like I said, just overhauled the IP and the fuel system. Thanks

Just finished IP overhaul was starting and running a few times checking for leaks etc. Shut it off, tried to restart and no power to the panel. The lights will not come on. Have been going over TM -24 and have no thoughts on where to start. I was looking for a breaker switch or fuse that could...

Roy 70, I would like to catch up with you to discuss. Send me a PM was about to take the one on there to a machine shop and get about 1" trimmed off. Look forward to hearing from you.

Good Morning, After getting fuel filter gaskets and internal parts for the pictured canister I sent earlier it will not seal as it is the wrong one. I have been searching for the right one, which is shorter by about an inch as shown on the right. Any suggestions.

I learned just how bad maintenance can be and the unit still run. I started with the fuel pumps and went on to change the fuel filters. I got Wix filters. When I went to install the gasket it was to large. The one I removed was distorted as it appeared not quite right, when installed. Can you...

Guyfang, I have been all over looking for the best way to get it out. It appears that it will have to come out the rear of the unit? All the TM's just show the plastic tank, but don't show the 3" between the engine and the tank. But as my brother always says" Piece of Cake" Love the unit, and...

Thanks for the TM's but I'am looking for the best way to remove the plastic fuel tank which has a hose leaking on the top. It looks like a beast. Thanks for the info.

I bought what I thought was a good TM but alas was lacking. I have toured the web but do not understand how to navigate all the military jargon. I did not understand how the trash I found made it's way to the separator. I just got it and the previous owner was not really clear on what he had...

When removing the water separator I found the trash in the bottom contained some leaf parts. What is the silver barrel that screws up the center in lieu of a standard filter? Also how tight do you screw it up?