Search results

Right there in the cap.

Tank is 32" wide, 60" long and 12" tall - 1/8" steel - 99.7 gallons when full. The two long edges were bent in a break and the short ends were welded in. The top edges were bent in a break to give the guys a lip to weld the top to. Blew a hole in the bottom of the generator case to run the...

Wish i could, but I had the guys in the back build mine as a favor (government project). I think it would be frowned upon to start up a production line! The tank has the same dimensions as the generator case, and approximately 13" tall, giving it a volume of just under 100 gallons.

I had the guys at our shop build it for me. Ran the aux fuel line through the case and plumbed it with the fill nozzle in the front bottom door.

Wet sanded the generator to get rid of the chalky tan and the gray came from Lowes. Made the stencils on a silhouette vinyl cutter. Searched for logos online, but nothing. Just typed up a couple different fonts that i liked.

Thanks to the help of several on this board, and specifically Kurt Klopp's one wire start and transfer boards, I've finally completed my whole house standby unit! Wanted to share the final outcome. MEP-803A 10k Generator 100 Gallon bulk tank pedestal Generac automatic transfer switch Auto...

New to the message board and new to my MEP 803a. Looking for info on auto start and auto transfer with my 803. Had a Generac RXSW200A3 auto transfer switch installed. Also purchased and installed a 2 wire remote start controller kit for the generator. Both work great, but still working on...

Tried that route as well - Napa and Oreilly's, with no success. You are correct - 450 to ~30ohm. 1/8" NPT

Hope this isn't too old of a topic to reply to! CANNOT locate a temperature sensor/sender for my MEP803a I've looked through the TM and located the part number ( 127338 ) and stock number (2990-01-366-0735) I've searched the internet with no success - Nothing on ebay. Tried a universal one...