Search results

Any troubleshooting steps on this gauge? I have 60.93 hz measured at the terminals on the gauge via fluke meter. Also, what value and units would you see when measuring the load gauge? Voltmeter works fine.

When it was running yesterday it had no load on it. I am suspecting an air leak because I have clear fuel hose going to every injector pump and I can see movement back and forth in those fuel lines from the injector pump to about 2" back when the engine is either cranking or running. I suspect I...

I am also wondering if I could be sucking air on the fuel filter housing...I just ordered a seal kit.

I am wondering if the governor is non-functional. All injectors have been replaced. When I try to start, it fires up instantly with black smoke then putters out after a second or so. I had it running yesterday for 15 minutes so I know there is not air in the fuel system anymore.

I will double check by cracking all injector lines at the injector. IPs are fully counterclockwise. Should they be adjusted slightly clockwise for more fuel? Maybe 2-3 notches? I have 3 more new injectors so I will put them in and then all 4 will be new. I did not shield from the fans...

I should mention, after 20mins running at the 30% load, 3 of them were about 300 deg f and #1 was about 200 deg F.

2010 Fresh fuel New filters New electric fuel pump 4 new injector pumps from Lister Petter Been sitting for an unknown amount of years. Got it running quite well however EGT on #1 is about 100 deg F lower than the other 3 when running at about 30% load and coolant is 175 deg F. Exhaust is very...