Search results

Will it really shut off in a loss of oil pressure situation? I have one gen set where I removed the oil pressure sensor completely and slaved in a direct reading gauge. machine still runs just fine and there is no sensor input to the computer for oil because it’s disconnected. so am I missing...

Does it really shut off the gen set? I have the cim completely removed and machine runs fine. I have another machine that has the electric oil pressure sender completely removed and gen set runs fine. So from what I’ve seen and experienced there is not much that will actually shut the machine...

The computer stay it’s just the cim I removed. Haven’t figured out how to remove all the computers yet, that’s next. see thread for what I did.

So I have figured out my issue. I would start the gen and it would run for a second or so then die. It was loosing fuel. I made a jumper to the positive and negative side of the solenoid on the injector pump and boom it runs perfectly. But as I have read on other threads this causes the start...

The cim from what I have discovered is just a display for the other computers on the back plain. Simply un-screw it and remove the cables. I have done this on three machines now and there is no change in operation. To block the hole I simply cut a piece of sheet metal to fit. I then went on...

I have a 30kw that the cim didn’t work so I removed it. the generator is in service working perfectly. I made a block out plate and added a water temp sensor and oil pressure sensor. I also got three amp volt displays and installed them. generator seems to be working fine. Has any one else...

Ok Sorry all was told to split up my thread. so I have a 60kw that will start then die. I haven’t shot straight 24v to high pressure pump yet. I have seen on other threads where that worked, but why is it not gettin to begin with. is the mpu not sending the correct signal? what would I be...

I have a total of 4 of the 6okw generator sets 1 operates just fine 1 would not produce power so i got a new voltage regulator and now it produces power sometimes. still trying to figure this one out? 2 of them will start then shutoff, I can keep them running on ether. I have applied the 24v to...