Search results

My fuel gauge is not working. Something is wrong with wire 128B some where between j7 pin 1 plug under the control panel and the sending unit. There is no continuity. Should I dig in the the j7 plug or just run a new wire? Any help would be appreciated.

M103a3

HI, I have a trailer "power plant" with two 803s and the sinewave / phase syncing load transfer switch. I tow it around with my F250. I turned the lunette on the trailer upside down to lower it a couple inches but it is still pretty high. I have to use a really big drop hitch upside town to...

I’ll send you a PM now. Thanks!

I’ll take 4.

Apologies in advance if its already here but I did not find it her. Is there a source for replacement DC Ammeter (M4)?

My 803 powered my House and Parents house next door for 41 hours straight. Not one issue.

Is the spacer so the float cannot go to the bottom of the rod? I need to replace a couple of mine. As well.

I would like to get a few spares of these switches. It looks like Im late to the party. Does anyone want to get in on another order. Ill take about 5 switcehs.

The load bank was $1,400 for 4 weeks. I only wanted it for one week and it was not much more to keep if the the month for some odd reason. I have some new to me MEP803s to test as I get them running, a a couple 002a that I will get rid of that I have had sitting for couple years and a 005 that...

I hooked up directly to the generator because I’m not familiar the transfer box. I was going to Test each generator individually then afterwards try out the transfer box. I would like to play with it. I haven’t seen a Video of one being used yet.

Mep-803 I rented a load bank. I wanted a 30kw but they only had a 100kw so I won’t be able to get much variations in the load to test with. I didn’t get as early of a start as I wanted. I fired the generator up and decided to let it warm up before I put some load on it. So I went the bath room...

Hello, this is my 3rd 803. I hope to install one at my parents house and another at mine for emergency power. I just got this mep started after doing some cleaning up, oil, filters, anti freeze, belts, quad fuse, mov then breaking free a sticky IP, fuel lines.... After getting this one started I...

Which electrical fittings do you need, id like to get a couple just incase.

I just had the same experience with a 803 with 500hours on the meter. It would crank and crank but would not Fire up. I pulled Injection pump #1 closest to fan. After fiddling with it I realized the arm was frozen. i took a small tool and tapped the arm over back and forth a few time until I...

Sorry about that, Please see attached picture.

I have a mep-803 Im going to get started working on. It has a few hundred hours on it. It did not run and had fluids drained. I notice there is some orange / rust stains on the head and block. Does it look like the head gasket blew out? See pic? Should I proceed to fire it up?

Took the top panel off to get behind S8 and do some inspecting and cleaning. Is so much easier to work with the top off. Need to order lots more SS hardware.

Thanks for the replies. I just wanted to see if that was a sign of something else to check before i crank them up for my first time. Quad fuse and mwo are done. Changed oil and filters, drained old fuel, Scrubbed fuel tanks, installed new well nuts. Going to replace coolant, belt and batteries...

Great. Thanks I’m gonna order a couple ASAP.