Search results

Does anybody know of any T2 (72-5004) transformers for sale? On mine the glue/epoxy and cardboard had delaminated and the wire inside to the x1 terminal broke off. If it wasn't such a thin gauge wire i would try a solder it back on. Or did anybody find a alternative transformer that...

Thanks for all the quick responses. I dont think the glowplugs/ preheater are the problems because it started the same this summer. I dont know if the glowplugs are working but i do know the preheaters are getting hot. I usually cycle them for 30-60 seconds before cranking . The linkage is...

I have a Mep-002a that is hard to start. It doesnt take very long for the generator to fire but requires alot of cranking before it stays running. Fires and dies. Fires sputters and dies. Fires and runs slow for two or 3 second. It will gradually get better until all of a sudden it just takes...

Thanks everybody for the quick responses. I found a switch on ebay a few hours after starting the thread, but thanks storeman, i will keep you in mind if i need to buy some parts in the future.

That makes sense. I was thinking i could use a toggle because of what i read on http://greenmountaingenerators.com/blog/ Manually “flashing” or “energizing” the unit is still possible by simply holding the switch in the Start position for a couple of seconds even after the unit has been...

I recently purchased an Mep-002a and during the normal prep work( filters, oil, fuel injecter pump cleaning) i broke the switch that kicks the starter out at set rpm. Not sure on the name, start control switch, starter kick out switch, starter over ride switch. Located below and to the right of...