Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I am rebuilding an 802a and had a bad fuel sending unit, checked by TM. I order a new on ebay but instead of a one wire and ground wire to the base, I have a 4 wire connector to the new unit. 2 red wires and 2 black wires. The bottom of this unit has 2 sliding tubes on an L shaped tube instead...
Had an excellent moment today! The battery indicator was not working and my kill solenoid on the injector pump would not stay up after put in run position. I looked through the archives because I had closed both heat and oil sensor with no result. I found one thread that talked about the K1...
I was looking at the forum archives and one problem that was identical to mine was the ground to the control box. I also have an hour meter that is not working. Will clean ground leads tomorrow and see if that works. Also I checked for voltage with a multimeter, not an ammeter. No ground to...
The single socket is a one wire lead to the battery indicator. The socket should put out about 26vdc. The battery indicator is grounded to the control panel.
Put new fuse in my 24VDC and all voltages are within spec. My battery indicator is dead as a hammer. Took off lead to check with ammeter. Absolutely no voltage to indicator. Where do I begin to look? 33v at stator, 26.6vdc at batteries. I still do not have an engine kill solenoid hooked up. Put...
Thanks for your reply. I just got on ebay and found some fuses as you described. I also found an asortment of old fuse caps. Thanks again for your help!
I looked on Eay. The one I saw was lots$$$. It was new but as long as it is functional I would be happy paying a lot less! I will check the classifieds.
I picked up my MEEP 003 Yesterday. Prepped it for starting and started first try! I have one missing piece> The fuel cutoff solenoid was carefully removed. (they returned its screws back to their holes) I looked everything over and the gen did not smoke during initial start. I looked at the 24dc...
I came across this site and found bountiful info. I have purchased a mep 003a to have as backup for my home. I hope to glean as much information as I can and someday return the favor to others. Thanks! This is this first forum I have actually posted on but I have been a member of others. I was a...