Search results

No

Oh new to website was nit sure if had to reply Individually and group will correct Thx

what is the bolt on part on the side of housing where cold advance solenoid is housed? thx

thanks for all the responses thought about pulling fuel line and putting it in external new fuel can see if that might be it

how is the pcb tested

how d

new control box next

well I think thats where am at they have a new box from camotek that removes most of the electronics and gives a manual glow plug switch herd of it

all resistance 2.5

checked all at 2.5

checked resistance all at2,5

checked it works per manual thx

checked all 8 plugs getting 24 volt

checked all 8 plugs getting 24 volts with wait light on

Thx Have not replaced control box yet working that way have not checked timing but would it not smoke all the time if timing off Sounds like it misfires a little while smoke clearing then no more after smoke cleared Thx

Glo plug light on for few seconds then off then start

Starts right up just pulled all glow plugs tested with battery then checked continuity then checked 24 volts at plug leads all good 75 degrees outside started smoke 15-20 then cleared and ran great 500 miles on motor bought at 100 no problems til 450

My 2005 1123 has heavy white smoke at start up then goes away when warm Already replaced injectors, glow plugs, advance cold start solinoid and glow plug controller on manifod Ideas Thx