Search results

I would happily support them if the price difference wasn't so huge. A single 4x6 trucklite is $150+, that'd be $600+ in headlights for a truck that gets driven twice a year. The Chinese ones are $75 shipped for 4. That why I made these brackets, to avoid having to spend ~$300 on the...

Finally got around to finishing them up yesterday. Just two would be more than sufficient, but 4 sure does give a cool look. WAY brighter than stock of course.

I have the doors listed on ebay, I would discount a little if purchased direct from me. Yes, they are expensive. I have three pairs of doors left that I don't currently have trucks to put them on, I will likely sell only 1 set in case I buy another MTVR or two. Basically ALL the trucks are...

Just think what it would be worth if it had doors and a roof! I can't imagine buying a $50k WORK truck I couldn't drive unless the weather was nice...

I am not factoring strength into the mix at all. I am just saying changing the hubs to 1:1 is stupid because of the gear ratio. It would DOUBLE the speed in every year, which would likely burn out the transmission in a hurry. Plus, why does anyone need an LMTV that will run 116? It's a great...

I won't say it's impossible, but changing the ratio THAT much would not be a good thing. At 2:1 the overall ratio is 6.xx-7.xx something, I don't remember exactly. 1:1 it would be 3.90. you would not have any low end power, and nobody needs a LMTV that will run 120mph or whatever it figures...

Farm bureau is who I use.

I made the brackets. Converted from the single to the duals.

These are the ones I got off eBay. $67 shipped+ tax for 4. I wired the DRL (which also makes the center eye red) in with the low beams. Saves from running a separate wire all the way to the headlights just to make them function. The red doesn't seem too noticeable honestly, but I haven't...

No clue on the brand of the lights. Just found some cheapo 4x6's on ebay. Tons of styles to choose from.

No. Not similar at all. Just envision a metal trash can lid, about that size/design.

These were around $70 shipped/taxed for 4 on eBay.

Looks like a success to me! Still have to cut brackets for the other side and finish wiring them up. Never drive my truck, but I guess now the headlights will be bright for it to sit here in the driveway.

Just get a fab shop to make one. I think it's about a 30" circle with a 3/4" lip welded on. You can make the brackets to hold it on.

You don't have to remove the shafts to roll one. Just be sure whatever you are moving it with can stop it assuming you won't be on perfectly flat ground.

Thanks

Having some HMMWV'S picked up when the EUC'S clear. As of right now I will have one spot on a trailer empty, large enough for a HMMWV, trailer, etc. Price would be at least $500 but I don't know the exact price at the moment. It is a fellow military enthusiast that drives a truck that will...

Welcome to the wonderful world known as Cat ECM's. One minute they work, next they don't....

I pulled a m920 with a m1009 once. Only had to move it about 1/4 mile, and we had someone in the m920 and an air compressor so he had brakes. We passed a state trooper, surprisingly he didn't do anything. The m920 pushed the m1009 all over the place, I would have been better off putting the...

I am sure any vinyl glue would work. Maybe check amazon for a pool patch repair kit, then cut a piece off the junk tarp as a patch. If you don't want to cut the junk tarp I can probably round up a tarp to cut some pieces off of and mail you a few pieces.