1952 GMC m135 for sale in New York/ Vermont pictures.

[John.Westlock]

I took some pictures of the rims and motor as that seemed to be what some people were most interested in. Sorry I didn't take any pictures of the whole truck because I didn't think to. I bought this truck primarily for the fenders, radiatior, pto, and some cab parts. Possibly the trans also. Besides it never hurts to have more parts than you need. I have an m215 so there are a number of parts I don't need. Any way here are some of the pictures. Robert

 

[John.Westlock]

Here is one more picture.

 

[RickO]

Robert,

I'm interested in the troop seat hardware and bed upright posts. Also, interested in the step-up brackets on the tail gate. What are you asking for them?

I can be reached at email: M56B1WW@yahoo.com

Rick

 

[Recovry4x4]

What is the status on the winch?

 

[hippiedude]

I would be interested in fuel tank if clean ?motor ?trans. ?t/c ? That truck has tons of parts......

 

[pa.rich]

OOO,OOOOO,OOOOOOOhhhh, That PTOOOOOO !

 

[pa.rich]

The fuel tank, pump and sender.

 

[westfolk]

What if I said I had a 1952 Memphis hardtop M135 w/w complete except bed and tranny(well and maybe a few small things) that I might part out? Plus I still have a pile of other stuff floating around that goes to the GMCs.

 

[hippiedude]

I`m intrested ....could possibly pull off a spring time road trip....for goodies.....

 

[pa.rich]

Any M211 windshield glass? Gas tank with pump and sender? Tires 900-20? Seat pads? Lie bulbs?Cargo bows and top?Let me know.

 

[pa.rich]

Hippie dude pick me up on your way out. I live just below Rt.17 on 81 in n.east pa.

 

[pa.rich]

Westfolk, How far are you from Binghamton ,N.Y.? Rt. 17

 

[westfolk]

It's 88 mile to hit Corning, then 74 to Binghamton. I still have two pieces of windshield glass cut for M135, etc.(GM). It is tinted windshield glass. I have tires, lights, I don't even know what all I have. I used to have around 20 of them. Now I am down to one running and one parts trucks. About ten years ago I switched over to M35. Most I mine went out in scrap. I know where there is(was) four of them sitting in a scrapyard. Odds are they are still there. I know the parts truck has one hell of a heater that sits under the bench seat. Rims, you need duals offset, or singles offset?

 

[hippiedude]

I could use heater....Army didn`t put one in my baby.....I have a pass. seat & 1 pc. of ciear glass.....

 

[westfolk]

The heater if I remember it right is from Memphis. It runs off the engine coolant. Takes up alot of the space below the bench seat. It can make you cook in that cab no matter what it's like outside. I know I have driveshafts, headlight rings, headlight guards, I think a compressor. This is just stuff that comes to mind. I might have sold some of it to people it might still be there. Haven't done much with the GMC for quite some time.