-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
anyone install a lockout hub on a rear axle?
- Thread starter kovi
- Start date
- 6,983
- 2,518
- 113
- Location
- Montevideo/Uruguay
- 806
- 830
- 93
- Location
- W.WA
For what it's worth, I found myself in a position a couple years ago trying to turn around on a narrow piece of land with steep drop offs on both sides. At one point, I had backed up and my rearmost axle was actually hanging in air. To be sure, I hadn't realized this or intended this at the time, but it was my center axle that saved the day.
- 3,249
- 3,335
- 113
- Location
- NORTH (Canada)
@montaillou If you had had a centre axle lockout, you would have locked that in very gingerly at that point, I suppose! The parking brake better work!
I also read a reply from a forum member that got hung up in a parking lot on the speed bumps and was unable to traverse without locking the axle in. Too much hassle IMHO.
I also read a reply from a forum member that got hung up in a parking lot on the speed bumps and was unable to traverse without locking the axle in. Too much hassle IMHO.
It would be handy just to relieve stress in cornering. I think it needs the axle splined.
If I wanted to tow very far, I would pull the axles and make covers. Only the splined outer part needs removed on the front. Front covers could use dished air tank heads and a flange. I almost made a set for 5 ton but didn't.
If I wanted to tow very far, I would pull the axles and make covers. Only the splined outer part needs removed on the front. Front covers could use dished air tank heads and a flange. I almost made a set for 5 ton but didn't.
- 806
- 830
- 93
- Location
- W.WA
The lateral movement of the axles helps with this, does it not? What kind of problems can this stress lead to?
- 6,983
- 2,518
- 113
- Location
- Montevideo/Uruguay
1) There shouldn't be much any lateral movement of the axles, on flat ground.
2) While cornering, the rear tires all follow a different turning radius, but since we have no inter-axle differential, there's always some wind-up, with the resulting tire scrubbing while on firm ground. Not so bad when unloaded, but really stressing all components when loaded to full capacity!