-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
CV boot clamp. How ? Tool?
- Thread starter voron0255
- Start date
- 5,611
- 2,916
- 113
- Location
- Metairie/La (N'awlins)
There are several styles but basically this is what you need:
https://www.walmart.com/ip/CV-Clamp...online&wl12=494200157&wl13=&veh=sem#read-more
https://www.walmart.com/ip/CV-Clamp...online&wl12=494200157&wl13=&veh=sem#read-more
Attachments
Thank you sir.
I do have them both. The tool one on the left, i use for a small clamp, i can't figure out how to use tool on the right, on the big clamp i have on the picture, i been using it in the past but with the different type of clamps/tie's.
This kind: https://www.amazon.com/Empi-W0133-1643984-EMP-EMPI-Boot-Clamp/dp/B001HLXFHG
I do have them both. The tool one on the left, i use for a small clamp, i can't figure out how to use tool on the right, on the big clamp i have on the picture, i been using it in the past but with the different type of clamps/tie's.
This kind: https://www.amazon.com/Empi-W0133-1643984-EMP-EMPI-Boot-Clamp/dp/B001HLXFHG
- 5,611
- 2,916
- 113
- Location
- Metairie/La (N'awlins)
You feed the slack through and tighten the screw/nut till the slack out and twist/cut the excess off and use the other pliers to tighten the nub like the smaller clamp is what I recall.