abh3
New member
- 236
- 3
- 0
- Location
- Florala, Al
I've finally got my replacement engine a few weeks back and now have arranged some time over the holidays to perform the swap...
Can those with experience make some suggestions to make the process easier?
I'll be working in my farm shop with comcrete floors (a blessing!), good lighting, air-tools and using a Dresser front-end loader to lift/manipulate. This is a one monkey show around here basically so I need advice... Is it possible to pull the whole front clip or is it easier in pieces? Any service better done with the engine out? Try to leave the trans on trans jack or just pull it all? Any do's/don'ts?
All input is appreciated.
Thanks!
Can those with experience make some suggestions to make the process easier?
I'll be working in my farm shop with comcrete floors (a blessing!), good lighting, air-tools and using a Dresser front-end loader to lift/manipulate. This is a one monkey show around here basically so I need advice... Is it possible to pull the whole front clip or is it easier in pieces? Any service better done with the engine out? Try to leave the trans on trans jack or just pull it all? Any do's/don'ts?
All input is appreciated.
Thanks!