Sorry if you guys addressed this a 1000 times
i am having problem trouble shooting this because i can not unplug the the connector on Gen 1
here is where I am (and thank you in advance for any help )
Gen 1 light stays on
battery 1 front is reading 12.4v when running which is same i get on red wire on gen 1 ( is this enough to say gen 1 no good? )
total voltage when running is 26
As I said can not remove connector on gen 1 would rather cut and splice wires if nec. Than try and find another plug if breaks
once again TIA from an old Jarhead
i am having problem trouble shooting this because i can not unplug the the connector on Gen 1
here is where I am (and thank you in advance for any help )
Gen 1 light stays on
battery 1 front is reading 12.4v when running which is same i get on red wire on gen 1 ( is this enough to say gen 1 no good? )
total voltage when running is 26
As I said can not remove connector on gen 1 would rather cut and splice wires if nec. Than try and find another plug if breaks
once again TIA from an old Jarhead
Last edited by a moderator: