So christmas eve was driving my deuce to pic up chairs for the next day. Started deuce up and backed out of garage and let warm up as I always do before driving. Was less than a mile from home and it just died. Towed it back home with my Jeep and put up till I could work on it. I suspected the fuel pump and replaced it with an external one from NAPA. Fuel is now fine but none comes out of injector lines so I pulled the head. Nothing looked out of place till I stuck my finger down in the hole where the bottom plunger goes in the pump. I found a little spacer and three prong thing that holds this to the plunger. One of the three prongs is broke and I can not reinstall it with out this little three prong holder. Now to the question. Can I get one of these at the local diesel injection place or where do I get one. Please help.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Hydraulic Head little part
- Thread starter sammi91
- Start date
- 3,021
- 221
- 63
- Location
- eldersburg maryland
a good diesel pump rebuilder will have it. don't forget to replace the 'o' rings
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 755
- 113
- Location
- Cincy Ohio
Those clips are like $15 from Ambac.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 755
- 113
- Location
- Cincy Ohio
Its been posted many times......maybe you should search!
Flyingvan911
Well-known member
- 4,709
- 158
- 63
- Location
- Kansas City, MO
Uh oh. Banned again!