• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Little oil drops...

.Max.Power.

New member
14
4
3
Location
Germany
Hey folks,

my CUCV is loosing oil. Very, very little, but I guess its not supposed to be like this. We are speaking of 5-10 drops per day. I found the hole where it comes out (don't even know why there is a hole). When I wipe it off, there is even no oil comming afterwards, as it is very, very little. Neverthelss, after a few hours I have some oil drops on the floor.

Any ideas how I can stop that?


Maxoil leak 1.jpg
 
Last edited by a moderator:

chevymike

Well-known member
596
463
63
Location
San Diego, CA
That is a drain hole and should be there. Typically if dripping from there, it would be the rear main seal is leaking. This hole allows it to drip out so you don't fill the area the cover is, full with oil. Typically rear mains will leak while the engine is running and once off it will stop leaking past the seal. Once any excess oil has dripped out, it won't drip until you run the engine again.

The fix it to replace the rear main seal. It could also be the back of the oil pan gasket leaking.
 

.Max.Power.

New member
14
4
3
Location
Germany
That is a drain hole and should be there. Typically if dripping from there, it would be the rear main seal is leaking. This hole allows it to drip out so you don't fill the area the cover is, full with oil. Typically rear mains will leak while the engine is running and once off it will stop leaking past the seal. Once any excess oil has dripped out, it won't drip until you run the engine again.

The fix it to replace the rear main seal. It could also be the back of the oil pan gasket leaking.
I guess I will replace those seals then, but doesn’t seem to be urgently if I see it correctly.
 

ehuppert

Active member
280
138
43
Location
Upstate NY
When we used to run these over the road at high speed (when almost new) these ALWAYS leaked a little oil. And, seemed like the faster you went the more they leaked! Maintenance section used to get pretty pissed seeing the puddles!

Yes, it's the main seal! Is it critical? Probably not unless you run it low!

With vintage British vehicles which also always leak it's called rust prevention!

Eric
 

cucvrus

Well-known member
11,466
10,401
113
Location
Jonestown Pennsylvania
It can also be leaking higher up in the engine. The valley under the intake has a hole in the rear and that is directed into the bellhousing rear of engine and that hole is where you will see a leak. The oil leak coming from higher up can be a vacuum pump seal or the vacuum pump itself leaking. Also the oil pressure sending unit can leak and cause the oil to drip down. Valve covers anything that leaks up top must come down. So before you dive into the rear main seal entertain the thought of checking everything up top. Fuel leak can make a nice oily mess as it washes the 35 years of grime and oil build up on the trip down thru the engine bell housing. Good Luck. But you are correct. It is a common issue and it is old enough to leak at the seals and gaskets all over. Good Luck. Proceed with caution, plan the work and discover the issue before going wild. Or just pull the engine and reseal everything.
 

Sharecropper

Well-known member
Steel Soldiers Supporter
1,836
987
113
Location
Paris KY
It can also be leaking higher up in the engine. The valley under the intake has a hole in the rear and that is directed into the bellhousing rear of engine and that hole is where you will see a leak. The oil leak coming from higher up can be a vacuum pump seal or the vacuum pump itself leaking. Also the oil pressure sending unit can leak and cause the oil to drip down. Valve covers anything that leaks up top must come down. So before you dive into the rear main seal entertain the thought of checking everything up top. Fuel leak can make a nice oily mess as it washes the 35 years of grime and oil build up on the trip down thru the engine bell housing. Good Luck. But you are correct. It is a common issue and it is old enough to leak at the seals and gaskets all over. Good Luck. Proceed with caution, plan the work and discover the issue before going wild. Or just pull the engine and reseal everything.
Ditto what Rick said. It’s a 36 year old engine so it’s bound to leak somewhere. Hail I’m 70 and I leak.
 

dougco1

Well-known member
Steel Soldiers Supporter
867
647
93
Location
Cooperstown NY
It can also be leaking higher up in the engine. The valley under the intake has a hole in the rear and that is directed into the bellhousing rear of engine and that hole is where you will see a leak. The oil leak coming from higher up can be a vacuum pump seal or the vacuum pump itself leaking. Also the oil pressure sending unit can leak and cause the oil to drip down. Valve covers anything that leaks up top must come down. So before you dive into the rear main seal entertain the thought of checking everything up top. Fuel leak can make a nice oily mess as it washes the 35 years of grime and oil build up on the trip down thru the engine bell housing. Good Luck. But you are correct. It is a common issue and it is old enough to leak at the seals and gaskets all over. Good Luck. Proceed with caution, plan the work and discover the issue before going wild. Or just pull the engine and reseal everything.
I would have bet the farm on a rear seal leaking on my M1009 a few years back. Turned out to be a cracked injector line at the injection pump that ran fuel down the valley and mixed with the oil buildup like cucvrus mentioned.
 
Last edited:

dougco1

Well-known member
Steel Soldiers Supporter
867
647
93
Location
Cooperstown NY
Five to ten drops a day?

I wouldn't even be thinking about it.
But if left "as is" to drip it acts as a "Poor Man's rustproofing" when driving down the road. I noticed my oil/fuel leak would leave small oil stains on the rear bumper and tailgate surfaces after a short drive. It also kept the weeds from growing wherever I parked.
 

nyoffroad

Well-known member
940
687
93
Location
Rochester NY
Check your CDR valve to be sure that crankcase pressure isnt forcing your small leak.
Good idea, also what oil viscosity is in it? I tried running a pure synthetic and a very small ream main leak turned into a smoke screen at 55+ (I lost a significant amount of oil). I went back home and swapped out that oil with regular 15-40 and went right back to a drip here and a drop there. Just a thought, YMMV
 

DeadParrot

Active member
213
47
28
Location
oklahoma city, ok
2nd the thought to leave it alone for now. I would do the checks for leaks higher up on the motor. If the leak turns out to be rear seals, just add to the 'to-do' list if you ever have to do other work on that part of the motor. You can buy a lot of oil for the price of a pan gasket and rear seal set.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks