joshua180422
Member
- 39
- 2
- 8
- Location
- Hawley PA
I am trying to find the cat oil filters for my LMTV and I am not able to find them. Any help would be great. Also maybe even the fuel filters.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
LMTV Cat oil filter numbers and yes I did try searching
- Thread starter joshua180422
- Start date
- 518
- 179
- 43
- Location
- Stoneville, NC
Oil Filter = 1R-1807
Fuel Filter = 1R-0751
Water Separator Filter ?
This is for an LMTV with CAT 3116 engine. Not sure about filters for the newer engines.
Fuel Filter = 1R-0751
Water Separator Filter ?
This is for an LMTV with CAT 3116 engine. Not sure about filters for the newer engines.
joshua180422
Member
- 39
- 2
- 8
- Location
- Hawley PA
Thank you.
- 1,579
- 542
- 113
- Location
- Greenback, TN
SS member Auctionaddict has a kit of FMTV maintenance parts in the classifieds: http://www.steelsoldiers.com/showth...l-trans-filter-kit-1079-stewart-and-stevenson
It's a great source for parts for us FMTV newbies.
A possible heads up on that CAT IR-0751 fuel filter. My early LMTV requires a shorter filter due to the power steering pump being located below the filter mount. Too bad because the IR-0751 is a 2 micron filter [edit: but 7" long]
. The shorter filter my M-1078 needs is a 7E9763 [edit: 5.5 inches, shown in the picture], a shorter filter but still good for 4 micron filtration. Auctionaddict's kit has one of those.
The Racor pre-filter (with the priming pump) element is Racor R45P, a 30 micron pre-filter. I substituted a Racor R45T, a 10 micron filter. Since I run nothing but the best Diesel I can find, at the most active Diesel pumps, a 'tighter' filter shouldn't plug things up too much faster, but YMMV if you go to the R45T. A NAPA 34407 is supposed to be a replacement and it specs at 30 micron so is a reasonable replacement.
My local Auto store cross-referenced the CAT primary fuel filter and recommended a Baldwin filter (and I won't even give the number). I looked it up and it was a 30 (!!!) micron filter. No thinks, might as well not have a final filter.
Bob
It's a great source for parts for us FMTV newbies.
A possible heads up on that CAT IR-0751 fuel filter. My early LMTV requires a shorter filter due to the power steering pump being located below the filter mount. Too bad because the IR-0751 is a 2 micron filter [edit: but 7" long]
. The shorter filter my M-1078 needs is a 7E9763 [edit: 5.5 inches, shown in the picture], a shorter filter but still good for 4 micron filtration. Auctionaddict's kit has one of those.The Racor pre-filter (with the priming pump) element is Racor R45P, a 30 micron pre-filter. I substituted a Racor R45T, a 10 micron filter. Since I run nothing but the best Diesel I can find, at the most active Diesel pumps, a 'tighter' filter shouldn't plug things up too much faster, but YMMV if you go to the R45T. A NAPA 34407 is supposed to be a replacement and it specs at 30 micron so is a reasonable replacement.
My local Auto store cross-referenced the CAT primary fuel filter and recommended a Baldwin filter (and I won't even give the number). I looked it up and it was a 30 (!!!) micron filter. No thinks, might as well not have a final filter.
Bob
Last edited: