I am trying to figure out how to rewire the harness that will go from a non-MIL radio (CB or Scanner) to a LS-671/VRC Speaker. I have standard CB civvy speakers; but I wanted to use the 671. I have looked over the schematics and it looks like the MIL Cable I have can be utilized by cutting off the connector that would go to the MIL radio, strip the appropriate wires and run one to 12 volt(+), 12 volt (-), and two to a mono phono plug that I can plug into the CB.
I was thinking that I would end up with a modified cable that plugs into the 671
Here is the speaker I want to hook up to the CB. The schematics and my drawing of the proposed cable are below.
The BLUE connector is where the cable enters the Loudspeaker. My schematic skills are not getting me anywhere and I don't want to fry any components.
In this drawing the connector has been removed and I have wires 1-4 and a phono jack. Anyone know what wires need to be hooked up to the phono jack and Power?
Anyone with radio skills that can come up with the solution? Help is appreciated.
I was thinking that I would end up with a modified cable that plugs into the 671
Here is the speaker I want to hook up to the CB. The schematics and my drawing of the proposed cable are below. The BLUE connector is where the cable enters the Loudspeaker. My schematic skills are not getting me anywhere and I don't want to fry any components. In this drawing the connector has been removed and I have wires 1-4 and a phono jack. Anyone know what wires need to be hooked up to the phono jack and Power? Anyone with radio skills that can come up with the solution? Help is appreciated.