roboconcept
New member
- 8
- 0
- 0
- Location
- AZ
Hey all, just bought an m1009 in PHX about 5 days ago, has been running great up until yesterday, when it descided not to start. No attempt to even turn over, just lights at 1/2 key turn and nothing at full ignition position. Based on what I've been reading on here, I'm inclined to think it may be the starter relay which is going out, but I'm trying to figure out how to be sure.
I've checked most of the wiring that appears relevant, but there's a lot and I may have missed something. replaced a dead fuse, no help. Batteries are both telling my multimeter about 13volts.
I'm down to go to NAPA and throw down some money on a new relay, I just wanna make sure I've done everything to make sure that's the problem. and if it is the relay, how do I keep it from happening again?
I've checked most of the wiring that appears relevant, but there's a lot and I may have missed something. replaced a dead fuse, no help. Batteries are both telling my multimeter about 13volts.
I'm down to go to NAPA and throw down some money on a new relay, I just wanna make sure I've done everything to make sure that's the problem. and if it is the relay, how do I keep it from happening again?