Trailfinder
Member
- 35
- 1
- 8
- Location
- Springfield,VA
Does anyone know where I can find side and end racks for a M101A1 trailer? Thanks.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M101A1 Trailer Side and End Racks
- Thread starter Trailfinder
- Start date
- 7,058
- 147
- 63
- Location
- Mid Hudson Valley NY
I'll have a set of NOS fiberglass M101 SIDES at the Gilbert PA show next week.
CGarbee
Well-known member
- 2,472
- 552
- 113
- Location
- Raleigh, NC
If you find the metal hardware, I have the dimensions for all the wood pieces on my website...
www.garbee.net/~cabell -- look on the index for "bedwood"
www.garbee.net/~cabell -- look on the index for "bedwood"
Anyone know if M105 metal pieces will work with a M101? I know the metal bows can be adjusted for width to fit either by just bolting into the different holes. I am really curious about if the sides metal will work though as I have all those M105 sides, and there are some with bad wood.
1956_4x4
New member
- 368
- 0
- 0
- Location
- Crestview, Florida
Thanks for the info on the wood for the bows. I was just going to do a search on this when I saw your post.CGarbee said:
Smitty
Trailfinder
Member
- 35
- 1
- 8
- Location
- Springfield,VA
CGarbee, thanks for the info. I'll have to start looking for the metal.
- 7,058
- 147
- 63
- Location
- Mid Hudson Valley NY
Anyone going to the Gilbert PA show, I have 5 top bows for M101 and both SIDEboards for the M101, but no front/back ones.. I'll be there Thursday afternoon, look for the blue Dodge pickup with the tan military trailer... Plus a ton of other OD iron stuff..
CGarbee
Well-known member
- 2,472
- 552
- 113
- Location
- Raleigh, NC
I'm going by memory (I'm at the office, my trailers are at home...), but the height of th sides are different, so at the very least you'd have to trim the M105 side posts. In addition, the M101 has rear gates so the uprights on the back corners have hinges instead of "hooks", also you need the plate with the latch for the center of each gate...builder77 said:
I think that if you had some M105 racks, you could make sides for a M101 that were functional, just not 100% the same...