-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M1079 AC Cable to Genset
- Thread starter fjdedrick
- Start date
- 6,066
- 4,418
- 113
I think 155mm has a plug that fits that and then you can fab a cable.
- 1,176
- 388
- 83
- Location
- Guymon, OK
What is the amp rating? 200 amp is just a little bigger than 100 amp. I have something that will connect, but need to know what size.
Edit. 200 amp connector is larger than the 100
Edit. 200 amp connector is larger than the 100
Last edited:
I'm going to say 200... I'll take pic of the box of that helps
Sent from my VS995 using Tapatalk
- 1,176
- 388
- 83
- Location
- Guymon, OK
Photos dont work, unless you hold a tape measure up to the connector
spankybear
Well-known member
- 880
- 904
- 93
- Location
- WA
spankybear
Well-known member
- 880
- 904
- 93
- Location
- WA
There's a cable on the e that may work... but 995.00 plus shipping
- 6,861
- 694
- 113
- Location
- Stratford/Connecticut
Replace it with a civilian twist lock. Convert to 120 240 single phase. Unless you specifically need 3 phase for something. The military cabling is expensive and overkill for most people.
I think that's where I am heading... Actually converting this into a coffee truck and am trying like **** to get a Genset Trailer.. Was hoping for a matching cable.. But looks like I may need to rewire.
Sent from my VS995 using Tapatalk
- 1,176
- 388
- 83
- Location
- Guymon, OK
By the dimensions, its 100amp. If you clean the data plates up that are right below the connectors, it will tell you what they are. Should look something like this.
![IMG_2272[1].jpg](https://www.steelsoldiers.com/data/attachments/499/499274-0212dc40eba18c6f1ba1992661673821.jpg "IMG_2272[1].jpg")
I have 2 female to fit that
I dont have an loose male plugs.
The male plugs I have are on an extension cord that cost me a pretty penny, but not as much as the one listed earlier.
I have 2 female to fit that
I dont have an loose male plugs.
The male plugs I have are on an extension cord that cost me a pretty penny, but not as much as the one listed earlier.
- 6,861
- 694
- 113
- Location
- Stratford/Connecticut
How much power do you need? You can probably mount a quiet inverter generator under the box.
I'm going to go remove the paint.... How much for the cable.... God I hate to cut it... I only need that female...
Sent from my VS995 using Tapatalk
- 1,176
- 388
- 83
- Location
- Guymon, OK
I would pull the one out of the dist. box and cap the hole before I sold the cable knowing it was going to get cut. Yes I know if I sold it, it is none of my business what he does with it, but go find another one and see how long that takes without paying an arm and leg.