Lobovianna
New member
- 11
- 0
- 1
- Location
- Sao Paulo, Brazil
Hello everyone, cheers from Brazil!
I have a 1986 M998, with 6.2 and 3 speed for 4 months now (all fluids changed and hubs checked).
While daily driving yesterday, it started loosing power as if there was a "clutch" problem or something similar. Revs went up but it would move slower and slower every time until almost not moving at all! I stopped it and pop the hood, noticing red fluid coming from the air filter case. I waited for it to cool down a bit and drove home (1 mile ride from where I was) to park somewhere safe - it rode fine.
I will look at it closely this weekend and was wondering if you guys could give me some light on this problem!
I read here on SS about two possible problems to check: 1) Vampire t-case (broken cooler loop) or 2) front seal in the transfer may be bad allowing the fluid from the transmission to enter the transfer.
Any of these is more common in this specs' M998? Tips on where should I start? I have basic mechanical skills and ZERO people with good HMMWV knowledge here in Brazil
Many thanks in advance and kind regards, Felipe
P.S. Attached a pic of my HMMWV in action here!
I have a 1986 M998, with 6.2 and 3 speed for 4 months now (all fluids changed and hubs checked).
While daily driving yesterday, it started loosing power as if there was a "clutch" problem or something similar. Revs went up but it would move slower and slower every time until almost not moving at all! I stopped it and pop the hood, noticing red fluid coming from the air filter case. I waited for it to cool down a bit and drove home (1 mile ride from where I was) to park somewhere safe - it rode fine.
I will look at it closely this weekend and was wondering if you guys could give me some light on this problem!
I read here on SS about two possible problems to check: 1) Vampire t-case (broken cooler loop) or 2) front seal in the transfer may be bad allowing the fluid from the transmission to enter the transfer.
Any of these is more common in this specs' M998? Tips on where should I start? I have basic mechanical skills and ZERO people with good HMMWV knowledge here in Brazil
Many thanks in advance and kind regards, Felipe
P.S. Attached a pic of my HMMWV in action here!